20 Most Recent
1998 Acura RL Questions & Answers
I have codes p1203-p1300 for 1998 acura rl
CODE P1203 CYLINDER NUMBER 3 MISFIRE CODE P1300 RANDOM MISFIRE DETECTED. POSSIBLE CAUSE BAD SPARK PLUGS OR FAULTY WIRES.CHANGE FUEL FILTER CLEAN FUEL INJECTORS. MORE THAN 1 CYLINDER MISFIRE COULD BE LEAN FUEL MISFIRE.
NEED A Radio unlock code, 1998 ACURA 3.5RL
This information is usually either written in or part of a sticker in the owners manual. Otherwise, you should be able to call your local Acura/Honda dealer, and provide them the vin number and they can provide you the code.
Code for acura 1998 RL radio
Look in all the paperwork for the code. If that does not pan out, contact the dealer that originally sold this car as they may have the code stored on their computer system. Lastly.Go here:
http://owners.acura.com/
Register your Acura and the follow the directions to acquire the radio code from Acura.
11/26/2014 11:26:05 AM •
1998 Acura RL
•
Answered
on Nov 26, 2014
Fire alarm will not stop beeping
check the fuse box for water ingress , this is a particular fault with this model ,if the fuse box is dry and shoes no sign of having water in it have the OBD codes read as will tell you which sensor is at fault
Remove replace ignition cylinder lock
most cars are same, and very hard. no steering wheel pull this time...cool.
the FSM covers it.
the alldata.com does too.
its mounted with security screws on most cars, (headless)
10 steps remove only. and air bags are mech,
killers, heed it.
- Disable the air bag system, as outlined in Section 6 of this manual.
- Remove the lower panel of the dashboard.
- Remove the knee bolster.
- Remove the steering column upper and lower covers.
- Unplug the connectors from the ignition switch.
- Remove the steering column mounting nuts.
- Lower the steering column.
- Center punch the shear bolts.
- Use a 3/16" (5mm) drill bit to drill out the heads of the bolts.
- Remove the shear bolts, then remove the lock cylinder assembly.
HOW DO I REMOVE THE IGNITION LOCK CYLINDER IN A 1998 ACURA RL
You have to replace the assembly if you can't pull the end of the key out. That is done by removing the steering column shroud and chisseling or drilling off the captive bolts which clasp the lock assembly to the column. Then refit the new assembly and tighten and snap off the new captive bolt heads.
HOW TO REMOVE IGNITION LOCK CYLINDER.
Look on bottom side of cylinder housing ther is a small round hole with a pin in it with lock cylinder in lock position press on pin and slowly turn cylinder to start position once pin moves inward around the on position pull on cylinder it should come out.
Not finding what you are looking for?