SOURCE: VW polo transmission
hi you need the seals replacing in the box when they are cold the become hard as they warm up they start to do what there are suppose to yates210456
SOURCE: vw polo driveshaft torx splines problems
Hi Ammar
If your torx bolt splines are shot.
Hammer on the surface face, with a long round drift to loosen the bolt threads slightly, and close up the torx hole, and try the torx splined socket again.
If no good try mole grips on the head of the bolt to loosen it.
If not enough room for them, try a chisel on the outer edge of the bolt, this normally does it.
Failing this try hammering on a slightly smaller external socket, than the head of the bolt, then try removing.
Good Luck !
Let me know how you get on.
A FixYa rating would be nice !
John
SOURCE: vw polo intermitent abs sensor light on dash have
They are an encapsulated device attached to the brake backplate so cleaning is via a pressure washer.
You could take an ohms meter and check the continuity of the opposite one and use that as a reference against the first
A lot of garages will just us the method of swop it out with a new one.
SOURCE: vw polo 1993 has it got transmission oil in it
half way down gearbox facing radiator should be an allen key remove it oil should come out if not top it up
SOURCE: crankshaft sensor for vw polo where is the
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing
387 views
Usually answered in minutes!
×