Check engine light stays on - 2006 Dodge Ram 2500 Cummins

Numerous Conditions May Cause Engine to Crank But Not ...

repairpal.com > Problems > Dodge > Ram 2500

2006 Dodge Ram Laramie 2500, 5.9i liter Cummins ... I know in the old days the dodges had a way about starting up an engine and that would be where.

White smoke, rough idle at startup - Dodge Cummins Diesel Forum

www.cumminsforum.com > ... > 3rd Gen. Powertrain
Jun 5, 2010 - 9 posts - ‎7 authors I have an 06 Dodge 5.9L that has a light white smoke and rough idle when first ... 2006Ram 2500 QCSB 4x4, 3" Carli coils w/ 1" Daystar spacer, ... Still ran good tho, dispite the exact conditions you describe on Cold Start up.

Have you checked the block pressure.There was a problem with the impellor coming loose on the water pump which causes low block pressure and reduces circulation.You should also check the vent line to the rad and make sure the jiggle pin in there is ok it sounds like the system may be air locking

Manual states possible (probable) engine control problem and needs to be checked by dealer. The big auto parts stores will scan for free and hopefully can point you in the right direction of what needs to be addressed. If not, get back to us with that code and we'll be glad to further assist you.

No, but it seems like a lot of extra work to pull the head if your going to pull the engine.

2004 Dodge Ram Cummins 4x4 will not shift out of 1st without letting off pressure to accelerator. Just started this prob today... all other shifts are normal.

have you tried changing bulb just to make sure filament is not messed up

have computer scaned to find out why. they will pull codes and go from there.

Hello mhak330: My name is Roger and I can give you the answer to your question. Locate the ECM on the drivers side of the engine.look for the bottom bolt holding the ECM. To the right of the bolt you should see the oil pressure sender unit. Should you need further help please just ask. Please rate the quality of your answer. This way we know you received helpful information. Thank You for using Fix Ya. Roger

my 06 2500 cummins shook like a log wagon until i change the u-joints. 35 dollars and a couple of hours. 

No, you don't have to remove the cab. Pull the radiator, A/c condenser, trans cooler and core support and pull it straight out the front.