Cars & Trucks Logo

Related Topics:

Gary Holy Posted on Oct 28, 2017
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Replace the battery on john deer z235 ride on, and now it wont start. Motor turns over of the starter motor but just wont fire.

2 Answers

roeb

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Master 819 Answers
  • Posted on Oct 28, 2017
roeb
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Mar 13, 2009
Answers
819
Questions
0
Helped
385258
Points
2343

Try jumpering the battery and see if it will start if so charge new battery.

richochet

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

  • Cars & Trucks Master 1,026 Answers
  • Posted on Oct 28, 2017
richochet
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

Joined: Feb 16, 2010
Answers
1026
Questions
1
Helped
294564
Points
2697

Check wiring again if it was running normal before ya changed battery

Ad

5 Related Answers

Anonymous

  • 405 Answers
  • Posted on Dec 29, 2008

SOURCE: 97 buick skylark wont start

if starter fluid made it chug, I would suspect fuel pump fuse, relay or pump, also fuel filter.

Ad

Anonymous

  • 15935 Answers
  • Posted on Jan 01, 2009

SOURCE: starter motor

Is there any sound when the key is turned? The solenoid may be stuck, and a light tap with a hammer may free it up. The starter is located on the engine block.

This is what you are looking for....
http://i8.ebayimg.com/02/i/001/22/0b/39e7_1.JPG


REMOVAL & INSTALLATION
STARTER MOTOR
Removal & Installation (2.0L)

CAUTION:When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. Before testing starter, ensure transmission is in Park or Neutral.

Disconnect negative battery cable. Remove air cleaner. Remove upper starter mounting bolts. Raise and support vehicle. Disconnect starter solenoid wire connections. Remove starter motor lower mounting bolt. Remove starter motor. To install, reverse removal procedure. Ensure negative battery cable is installed with starter mounting bolt. Tighten bolts to specification. See TORQUE SPECIFICATIONS table.

Removal & Installation (2.5L)

Disconnect negative battery cable. Remove air cleaner and air cleaner bracket. Disconnect starter solenoid wire connections. Remove starter support bracket. On manual transmission equipped models, remove shift cable bracket and disconnect cable. On all models, remove fuel supply line from support bracket. Remove starter bolts. Remove starter. To install, reverse removal procedure. Tighten bolts to specification.

Anonymous

  • 36 Answers
  • Posted on Feb 26, 2009

SOURCE: 03 Hyundai elantra wont start

it you can hear the starter motor spining but is not engaging into the fly wheel then the starter motor will need to be re-conditioned or replaced

Anonymous

  • 16 Answers
  • Posted on Mar 29, 2010

SOURCE: mercedes vito 110cdi starter motor problems. only when the van

1.)its the alarm system cant be nuffin wrong with the starter motor i had i problem i changed the battery put a new one on and it did it so all i did was put a switch on the wire were you connect the battery very time you get in the car switch it on and strat the car in one go but evey time your job is finshed with the car switch it off but your alarm system anit gona work then
2.) but a extra battery pack the ones they use on sound systems in cars

Anonymous

  • 107 Answers
  • Posted on May 26, 2010

SOURCE: 98 honda crv wont start unless bump started, starter motor?

will it start with a boost? either the starter motor or the battery. take the battery to auto zone and they will test it for you.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the starter relay located on a 1991 Toyota VX 80 Series?

If the Toyo has a Nippon-Denso starter, the Solenoid is the Relay....It is an integrated function to engage the drive gear and high amp motor run to turn the engine over....What are Your symptoms.....The 14 ga. Black wire with white stripe connected to the solenoid is the signal from the ignition switch.....low voltage here will not actuate the solenoid......John Deere sells a Relay that taps the battery terminal at the starter for signal voltage...The Black wire with white stripe will trigger this relay at a lower voltage......Really nice set up if installed properly.....Everything is right at the starter and no voltage drop at the solenoid......Ask John Deere for Starter Relay Mod. The will know what you talking about....Don't forget to disconnect the negative battery cable before installing the relay kit........
0helpful
1answer

John deere x320 wont start have to turn key 5 or 6 times

Start with the battery.
Have it tested.
Then, look at the terminals and wires.
Corrosion can cause this.
Next, go to the starter and the starter solenoid.
The solenoid or the starter will be most likely your problem,
God bless your efforts.
0helpful
1answer

John Deere D130 lawn mower wont start?

hmmm seems like the internals of the starter motor arent doing so well as if the windings inside of it are bad and need work on or the starter being replaced if the same happens with the new starter it could be the start salvaniode bad and need of replacement
0helpful
2answers

2003 accord 4cylinder wont start doesnt turn the battery is good

check battery connections, if they are good check the power supply from the battery to starter motor (thick cable), if this is good have someone crank it while you check the signal wire to the starter motor(thin wire), if this is good replace the starter motor. u could tap the starter motor with a hammer if accessible while someone is cranking it, sometimes this will get the starter going again but will still need replacing
0helpful
1answer

1999 grand voyager clicks once but wont start. has done in past but usually after a few turns the motor starts again

Hi Chris, Try cleaning the battery terminal. You may need to remove them and clean oxidization from inside. If that does not work you may have a problem with the starter relay or starter motor. Regards John
5helpful
3answers

Starter turns but wont engage engine?

Sounds like the Bendix... You might ought to pull the starter and look at the teeth on both the bendix of the starter and the flywheel. If the teeth on both are in good shape...then its probably a weak starter not throwing the bendix out to turn the flywheel. But...if the teeth are **** up on the bendix...its cheaper tp replace it. Make sure Battery is in good condition as well. Both battery AND starter can be tested at your local AutoZone... Hope this helps...
0helpful
1answer

Changed the plugs wires and cap and rotor...think I might have screwed the firing order up....no misfire just wont turn over.

the wires to the plugs should not keep the motor from cranking over. If the battery is fully charged the ignition switch should engage the starter. If you think the firing order is wrong you need to determine 1 where is top dead center (the position the motor is in when #1 cylinder is at the top of the compression stroke). 2 what direction does the rotor turn 3 what is the firing order One way to make it easy to rotate the motor is to remove the spark plugs. no compression means no resistance to the starter so the motor should turn over with the key in the start position. If it won't crank over with the plugs out then something is wrong with the starter, battery, starter relay, or ignition switch. I always start with the basics. the battery should have at least 12.5 volts. if it does check the battery terminals. even if the starter is weak you should hear a click when the key is turned to the start position. Once you get the starter to turn over the motor you can tell when the number one cylinder is at top dead center by putting a finger over the spark hole as you crank over. You will feel the compression as the cylinder comes up on the compression stroke. I have used a large socket to slowly turn the motor over and when you are near top dead center you should be able to see the degrees of advance on the timing mark. Set the motor at top dead center then see where the rotor lines up with the wires on the distributor cap. that is where number one cylinder should fire. You then follow around in the direction that the rotor turns and the wires will corispond with the firing order. I always make a mark on the number one spot on the cap with a felt pen. That way you have a fixed reference point. Take care to verify that all the wires are to the proper plugs before trying to start. Take extra care at this point and make sure your firing order and rotor rotation are correct. I would triple check this. The firing order and rotor direction are usually somewhere on the autozone repair web site
1helpful
1answer

98 honda crv wont start unless bump started, starter motor?

will it start with a boost? either the starter motor or the battery. take the battery to auto zone and they will test it for you.
0helpful
1answer

Wont fire up. sounds like it's going to start but just wont turn

Hi,
It could be a couple of things:
  1. The starter motor needs repairing.
  2. The starter relay maybe faulty.
If you can get it to a good Autoelectrician they will definitely find the problem quite quickly. 9 times out of 10 its either the battery is faulty or the starter motor needs repairing. Hope this helps, let me know how you get on.

Jason
0helpful
2answers

Engine turns but does not start

you will need to replace either the ignition barrel or the starter motor
Not finding what you are looking for?

164 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...