Follow top radiator hose to engine. Should be near there by thermostat housing.
Front of intake on the drivers side see link
DIY Coolant Temperature Sensor change PICS Club Lexus Forums
SOURCE: Location of coolant temperature sensor
Maybe this will help . although this is from a 1997 Caddy.
Cadillac DeVille Engine Coolant Temperature (ECT) Sensor Location
SOURCE: location of the coolant temperature sensor
You will find this sensor where the fat hos comes from the radiator and conects to the engine block. It would be on the housing where the thermostat is located. If it is not there you should look for a sensor that has a wire connected to it anywhere on the engine block where a water inlet is located. I hope this helps. Don't forget to rate my answer, thanks.
SOURCE: replacement of coolant temperature sensor
located under intake in water crossover pipe,you can access the sensor by removing intake chamber box,then pcv hose connected to the block,the connector is orangeish 2pin,use a 19mmdeep socket on a 3/8 ratchet to get it loose,make sure engine is cool,also make sure there is a new brass washer with your new sensor,sometimes the old washer comes off when removing the sensor,sometimes it sticks to the pipe,some coolant will escape so make sure to top it off
SOURCE: 1993 Lexus LS400 acceleration stalls or surges
I HAD THE SAME PROBLEM WITH MY CAR. 93 LS 400. THAT WOULD BE YOUR FUEL FILTER OR THE FUEL PUMP GOING BAD. TRY CHANGING THE FILTER FIRST. THE DEALER TRIED TO CHARGE ME $980 TO CHANGE FUEL PUMP.
SOURCE: I have a 1998 toyota corolla and need to replace
Follow the hose from the bottom of the radiator to the point where in reaches the engine block. That's where the thermostat is located and the Engine Coolant Temperature switch is there too.
694 views
Usually answered in minutes!
×