2007 versa hatchback.Previous owner had wheels and tires with no senors.I put new wheels and tires on today with sensors.tpms is still on.I have a tool to reset and it sees the sensors but i don't know how to put the car in learn mode.Anybody know the procedure for learn mode in this car
To activate a new transmitter in the tire pressure monitoring system WITHOUT the Nissan Consult scan tool: Under the dash above the OBD II connector is a single wire connector called the "tire pressure warning check connector". Use a jumper wire and ground the tire pressure warning check connector with the key OFF. Then turn the key ON and cycle the ground at the tire pressure warning check connector 5 times within 10 seconds of turning the key ON. This should cause the tire pressure monitor light to start flashing indicating the system is in "learn mode". Then use the activation tool starting at the left front tire and work around the vehicle in a clockwise direction - front left, front right, rear right and rear left. Activating each transmitter at each wheel should make the turn signal flash one time and after completing all 4 wheels, the turn signals should flash two times and all 4 time pressures should be displayed.
SOURCE: Nissan 2007 Frontier tire pressure monitoring system
check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well
Hope that helped
Nissan tech +6 years
SOURCE: I need workshop/owner manuals to download for a
I can help you with the owners manual. The link below will take you directly to the 1996 sentra owners manual. It is not specific to body style, as the hatch back had the same manual as the 4 dr coupe and the sentra SE-R. Good luck! I hope you find this very helpful!
http://www.nissanextendedwarranty.com/owners-manual/nissan/1996-Nissan-Sentra.pdf
Testimonial: "The owners manual helps heaps.Thank you very much. Would still like to track down a workshop manual if possible.Thanks again."
SOURCE: need to reset auto lock function on 2009 versa
I think this is a feature that needs to be reset by a mechanic.
SOURCE: 207 Nissan Versa... the Tire
Nisson has pressure sensors in the tires check air pressure sensor in one tire could be the problem have xterra did the same thing one stem could be bad
SOURCE: We have a 2007 Nissan Versa SL and need to replace
Here's asite that will explain everything you need to know about airbag systems, airbaglights and resetting the system. Itshows you the location of the components and the procedure for diagnosingand/or resetting airbag light. Not allvehicles need everything replaced. You cancheck to see if your car is listed here. http://www.airbagsolutions.com/ Airbagsolutions.comalso has the fault code charts to tell you what is wrong and how to fix it! Some vehiclemanufacturers let you access and reset systems without a scanner (like Toyota,Lexus, Nissan, Infinity, Honda, Acura, Ford, Lincoln, Mazda & Mercury) andsome require a scan tool. Althoughit's a pay site ($14.95/day), it's a lot cheaper than going to the dealer Here's the page in this site that tells you which cars needa scan tool and which ones can be done without I hope I've helped you http://www.airbagsolutions.com/scanlist.aspx http://www.airbagsolutions.com/light.aspx http://www.airbagsolutions.com/vehicles_list.aspx
check for 12 volts at the heater circuit feed (hint: unplug the sensor and check at the wiring connector to do this measurement).
check the ground circuit for continuity.
measure the resistance of the heater circuit (done on the sensor itself).
measure the resistance and voltage of the wiring.
390 views
Usually answered in minutes!
×