2004 GMC Envoy Logo
A
Anonymous Posted on Oct 13, 2014

My 2004 gmc envoy reading said running to lean

1 Answer

Denis Houle

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • GMC Master 1,414 Answers
  • Posted on Oct 15, 2014
Denis Houle
GMC Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Aug 02, 2013
Answers
1414
Questions
0
Helped
498624
Points
4096

Engine code,fuel pressure,bad fuel,o2 sensor, map sensor, coolant sensor and so on
with scanner look read data to see data out of range . code will set only for short to ground or open circuit

hope it helps

5 Related Answers

Anonymous

  • 91 Answers
  • Posted on Aug 06, 2008

SOURCE: 2004 GMC Envoy has trouble idling

Try the fuel filter. Sounds like the engine might be running rough due to weak fuel pressure. Its cheaper to replace, especially if it's still original from 04. Try running some injector cleaner through a couple of tanks of high octane gas.

Ad

Anonymous

  • 250 Answers
  • Posted on Jan 28, 2009

SOURCE: battery removal on a 2004 GMC Envoy

The battery is on the right side behind the fuse box. You need a metric set to undo the 3 screws. Theres one that attaches to the body, one to the bar that goes along the top, and theres one on the left side below the vacuum hose and air induction. After you've taken out those three, you should lift the whole thing out(battery and shroud) together. It's hard to take the shroud off before you lift the battery out. After that, you have to pry the shoud off the battery. The two terminals in the back make it hard. Then just go to any auto parts store and they'll give you a new one. 

Anonymous

  • 2 Answers
  • Posted on Jun 05, 2009

SOURCE: Speedometer on 2004 GMC Envoy not working. It

There is a recall on the panel Cluster... call your dealer and have it checked out.. mention the recall... www.lemonauto.com

Anonymous

  • 82 Answers
  • Posted on Mar 25, 2010

SOURCE: 2004 GMC Envoy rear hatch complete door wont

door lock actuator solenoid ( inside of door) needs to be replaced

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jun 04, 2010

SOURCE: what is the best type of motor oil for 2004 GMC

this engine calls for any major brand 5W20W (I prefer Valvoline), in very hot climates u can use 10W30W, but no heavier.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I'M having a P0171B and a P1133 on my 2004 gmc

P0171 - Bank 1 system too lean.

P1133 - O2S insufficient switching bank 1 sensor 1

go to autozone and have them read your vehicles computer ,,,or take your battery cables off for 10 minutes then put them on and see if it resets itself ...most likely a code misread on your vehicle
0helpful
1answer

GMC Envoy

sounds like the inst cluster
1helpful
1answer

2004 GMC Envoy- Whenever the heater is turned on the RPM drops to about 500RPM and sometimes dies. What could be causing this problem?

The throttle body needs to be cleaned, grime in this area prevents the throttle plate from closing completely and allowing air to enter, making the air/fuel mixture lean.
2helpful
1answer

2004 GMC Envoy. My ac is causing my engine to fluctuate in RPM's and will cause engine to die somtimes. If I turn ac off it will idle just fine. Need help.

The throttle body needs to be cleaned, grime in this area prevents the throttle plate from closing completely and allowing air to enter, making the air/fuel mixture lean.
0helpful
1answer

My 2005 envoy stalls when you turn the ac on.you can keep it running if you give it gas.

The throttle body needs to be cleaned, grime in this area prevents the throttle plate from closing completely and allowing air to enter, making the air/fuel mixture lean.
0helpful
1answer

2004 Envoy: why does my envoy want to die when i turn on the a...

The throttle body needs to be cleaned, grime in this area prevents the throttle plate from closing completely and allowing air to enter, making the air/fuel mixture lean
1helpful
1answer

2004 GMC Envoy check engine light remains illuminated. Diagnostics revealed codes: P1133 and P0128. P1133 points to a heated oxygen sensor and P0128 indicates a possible defective thermostat. The O2 sensor...

Leave 02 sensor alone ,it is doing it's job . It is heated up because of lean fuel mixture due to incorrect engine temp.,replace thermostat before looking further.
3helpful
1answer

2004 GMC Envoy with a P0526 sensor problem

This code indicates a problem with the fan clutch, the speed it is running is not the speed it was commanded to run/ The fan clutch assembly needs replacing.
1helpful
1answer

No cold air w/air conditioner on for a 2004 GMC Envoy.

Can't go by the pressure. Ck the large lone coming out of firewall, should be col. Small line at ac condensor in front of radiator should be hot.

Static pressure on high side probably 80psI Running 30 on the low side and 1130. will vary depending on oiutside temp Hope this hekoped
Not finding what you are looking for?

216 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...