Trouble Code: P2404 (2.0L L4 VIN 5 Automatic CVT)
Evaporative Emission System Leak Detection Pump Sense Circuit Range / Performance
Number of Trips to Set Code: 1
Trouble Code Conditions:
EVAP vent valve stuck open: EVAP leak check pressure is lower than -0.14 kPa even if EVAP vent valve is operated from OFF (OPEN) to ON (CLOSE) with EVAP leak detection pump ON. EVAP vent valve stuck closed: EVAP leak check pressure is unstable (difference between maximum and minimum is 0.36 kPa or more) when EVAP vent valve is OFF (OPEN) with EVAP leak detection pump ON. EVAP leak detection pump stuck OFF: EVAP leak check pressure is higher than -0.14 kPa even if EVAP leak detection pump is ON. EVAP leak detection pump flow high: Reference pressure of EVAP leak check pressure is lower than specified value (depending on BARO) EVAP leak detection pump flow Low: Reference pressure of EVAP leak check pressure is higher than specified value (depending on BARO).
Possible Causes:
SOURCE: need radio code fro 2007
Well the only way to get codes is by stopping in to Suzuki on the service drive and ask someone to get and put the code in and they will
SOURCE: 2007 suzuki sx4 emission control light on. 17000 miles
My light in my 2007 SX4 just came on. Apparently my oxygen sensor is wrecked... allegedly from oil dropping on it during oil changes. Did the light come on after the most recent oil change?
SOURCE: How do I put my 09 Suzuki SX4 AWD in lock position ?
In addition to Don's comments above, here is a little more information. The 'lock' feature manually engages the all-wheel drive at low speeds only (less than 50 kmh, or 30 mph). It is intended for use in situations like deep snow which you need to drive through at low, preferably steady speeds, where extra torque to the wheels is required. Most of the time, I just leave mine set to 'Auto', which as Don says engages the all-wheel drive only when the onboard computer detects one or more wheels starting to slip on the road. Once control is regained this will automatically revert to front-wheel drive only. This is a great feature! I suggest driving with this switch in 'Auto' all the time. It will not adversely affect your gas milage, unless you are driving agressively on slippery roads a lot.
Jeff - 2008 Suzuki SX4 AWD owner.
SOURCE: where is the knock sensor located on my 08 suzuki sx4
The P0327 means Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor).
the knock sensor is located in the front of the engine located behind the oil dip stick just to the left.
_______________
Ktag K-TAG
2,976 views
Usually answered in minutes!
×