Have a po327 code eng light is on
The P0327 means Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor).
the knock sensor is located in the front of the engine located behind the oil dip stick just to the left.
_______________
Ktag K-TAG
SOURCE: Need to know where the
It's on the side of the block (marked 6), near the rear as seen in the picture of your engine below.. It picks up its signal directly off the crankshaft throw.
SOURCE: I'm trying to locate the spark plugs in my suzuki 2008 sx4.
You remove the rectangular plastic cover on top of the engine(2 screws), under that is the plug wires and spark plugs. Pull wires straight up, remove plugs with proper spark plug socket, extension and ratchet, reverse to install.
Platinum plugs are not required but will allow longer change intervals. Check the gap but do not gap them, if they are not properly gapped. Bring them back and asked for new ones.
The metal's on the Platium plugs are harder then copper plugs and can break upon trying or break in your cylinder when in uses.
Good luck and hope this helps
SOURCE: Suzuki Forenza 2004, check engine light is on, and
the bank 1 sensor is the one before the cat
SOURCE: 2007 Suzuki sx4 engine light on after oil changed
The solution is that when the oil filter is removed, oil gets on the O2 sensor and ruins it. Must cover the O2 and that keeps the oil off. To keep the check engine light off, is to replaced the O2 sensor. Problem solve. Later on sx4's they move the O2 in a different spot. I work on Suzuki cars. Don
8,084 views
Usually answered in minutes!
×