Remove rear outer door handle - 2011 Dodge Journey

You have to remove the door panels and this takes special tools. Then you remove the window and then you can get to the door handle mounting bolts. It might just be the linkage to the latch from the handle.

I need tore place my out here outer door handle on drivers side as well I already replaced the drivers handle but the back handle seems to be a bit harder to get to does anyone have a simpler way because this is frustrating I can't get a socket or a wrench in the door to remove the bolt... Any help would be appreciated thank you so much

This would involve most likely rolling window to the bottom as far as it will go and then opening door. Remove door panel and trim and use a flashlight to look for the fasteners holding this to the door. This should have 1-2 rods that are held in place by plastic locking pieces and clip to the outside of the rod and I side the whole in the handle.

2004 x3 Rear passenger door handle came off/apart. What are the steps to remove the inner door panel to access the door handle and repair it?

As per the Haynes manual for your vehicle.
DOOR WINDOW GLASS-REMOVAL AND INSTALLATION:
1. Remove the door outer panal.
2. Lower the window glass.
3. remove the two nuts and one screw securing the glass.
4. Remove the glass by lifting it up carefully and rotating it inward.
5. Installation is reversal of removal.

DOOR OUTER PANAL-REMOVAL AND INSTALLATION:
1. Remove door trim panal.
2. Remove the outside mirror. Remove the foam block from the mirror opening.
3. Remove the outside door handle.
4. Open the door and pry thhe outer sealing strip out of the window glass opening.
5. remove the door panal screws.
6. Detach the front and rear of the outer panel, then lift it toward the rear to remove it.
7. Installation is the reverse of the removal procedure. Apply thread locking compound to the panel retaining screws.

OUTSIDE DOOR HANDLE-REMOVAL:
1. Pull handle out and puch the centers of the retaining pins through the pins, then remove them and detach handle. (These pins are located underneath the handle.

Hope this helps, let me know if you need any other help.

has to remove the inside panel door and remove the clip inside to open the handle cover then u can see the two nuts and remove them

go to ebay motors and search your year make model then service repair manual obtain a cd repair manual it has extensive wiring schematics and electrical component locator in it along with repair procedures and illustrations for about $20.00

If it's the outer panel the door handle is held on with a small push pin.You remove the inner portion & then remove the outer part.Then lift door handle up & slide forward.It shoukld come off.1996-1999 Sedan the regulator can be removed with just the inner door trim removed.hope this helps

Lower hole in the door jamb loosten allen screw until the cap comes off. Upper hole there is a #20 torx slightly down and inboard of the hole, you need a really long torx bit and pull the handle out slightly. It also helps to pull weatherstrip loose so you can see it.