SOURCE: how to take out and reinstall new axle on 1996 toyota corolla,
1. Jack up and support car on jack stand. Make sure to chock wheels and or lock the parking brake on.
2. Remove wheel
3. Remove cotter key, castle lock and nut at center of rotor that attaches the axle. - If you lack and impact gun to remove this - it is easier to loosen this nut with all of the wheels on the ground.
4. Remove outer tie rod from spindle, Tap out with hammer. Should not require much force.
5. Remove the single bolt from the lower ball joint and separate from spindle.
6. Pull axle out of spindle and remove from transmission. This may require you to drive this out with a hammer and punch ( I use a brass punch), make sure not to damage threads if you intend to reuse the axle.
To install reverse the procedure. Make sure to replace any cotter key removed with new ones during install.
Torque specs you need are
Ball Joint to Spindle = 91 ftlbs
Tie rod to spindle = 36 ftlbs
Drive axle hub nut = 166 ftlbs
SOURCE: 2003 Toyota corolla A/C compressor not coming on fuse good, A/C charged, no pwer at compressor
it is located in the engine compartment fuse / junction box it is on the drivers side then cover to the box will show you witch one it is ( the relay will be white in color)
SOURCE: I need to know where
Fuel Pump Relay Notes If you remove the Glove box door & Box it is Just Above the Glove box hidden behind the dash. There is another one in relay Box BUT it is Wired into ECM this is NOT the one need trust me.
SOURCE: Pressure Control Solenoid "D" location on a 2005 Toyota Corolla?
this solenoid is part of the solenoid pack that is located on the valve body inside the transmission.
SOURCE: were is the fuel pump relay located on a toyota
In the engine compartment there is a black plastic box and inside this in all your main control fuses and relays.Thank you for asking.
844 views
Usually answered in minutes!
×