I have a 95 dodge ram 1500 318 just did a rebuild on the motor and i am am having problems timing it I have put it in timing but it seems it keeps getting out of timing.. it have a new timing chain and dis.. And answer to point me in the right way would help

Replace the motor/module on the transfercase. It has an internal short. Don't replace it. Soon you will have to replace or rebuild the transfer case and the motor.

The torque values are 85 ft/lbs. Tighten the bolts in at least three stages, the first tightening should be 30 ft/lbs and then at least twice at the full torque of 85 ft/lbs.

There are ten head bolts and the order is as below:-

9.........5..........1........3.........7
Front
10.......6..........2........4.........8

GO TO HOME DEPOT OR LOWES THEY CAN TELL YOU WHAT TO PUT DOWN AND AROUND VAN TO KEEP RODENTS OUT.YOU NEED A FEW CATS AROUND THAT CAN HELP SOME.

physically it will fit ,, but you run into problem with the fuel delivery and sensors because of the years difference,,, you will have to use the intake off the 95 but use 5.9 injectors and use all the sensors off the 95

Most likely, the reverse part of the transmission has probably gone bad.

Assume you have tried earseing those codes and they keep coming back?
May have a loose or bad ground the engine harness sensor circuit.

i also have 1999 ram desil. that had similar prob. the contacts on the starter were bad. so i got new contacts from a alt.starter rebuilder for 10.00 and put them in and fixed the problem.

No it will not. I have a 95 and am on tranny number 5. I had always put in used ones because I didn't know how long I was going to keep the truck. Now I have so much in it I have to keep it.
Anyway, back to your problem. 94 & 95 are all by themselves. Dodge had alot of problems with trannies in those 2 years and in 96 they attempted to remidy that problem, but didn't quite get the job done. The trannies will look alike until you take a closer look. In 96 they changed the wireing that goes to the computer so these transmissions could not be interchanged. One thing I would reccommend if you do find a used tranny to put in. Buy a brand spanking new torque converter.
BTW I did find one site for used parts that has come in handy several times. Car-Part.com Give it a try and good luck with your project.
I hope this helps you out, if so let us know and don't forget to rate me.
Thanks!

i just did a swap on same truck same motor .as long as you change intake and accessories and motor mounts.and valve covers everything should be fine please rate this answer thanks.

sounds like wiper motor is tied up. new wiper motor.