20 Most Recent
2004 Ford Freestar - Page 9 Questions & Answers
Where are the o2 sensors
O2 sensors are fitted at the exhaust end of the cat converter
The HO2S sensors are fitted between the exhaust manifold and the cat converter. Each has a definite operation and cannot be mixed up.
3/2/2015 5:36:37 AM •
2004 Ford...
•
Answered
on Mar 02, 2015
My cruise control does work, push button to set then nothing
After much research & frustration, I learned this seems to be a fairly common problem with the Freestar. (along with many other problems.) We replaced the Brake Pressure Sensor and it corrected the cruise control problem and the Traction Control light. I think the part was about $30. & we were able to replace it ourselves. Hope this helps!
2/22/2015 8:17:23 PM •
2004 Ford...
•
Answered
on Feb 22, 2015
Install a belt tensioner in 2004 freestar
2004 Ford Freestar:
Accessory belt drive removal and installation:
1.Put the vehicle in neutral, and put it on hoist.
2.Rotate the accessory drive belt tensioner counterclockwise.
3.Push the spring clip towards the belt tensioner to lock the accessory drive belt tensioner in place and remove the belt.
4.To install the accessory drive belt, on the engine, rotate the accessory drive belt tensioner counterclockwise till the spring clip releases.
5.Install the belt.
2/1/2015 8:06:15 PM •
2004 Ford...
•
Answered
on Feb 01, 2015
How to replace a belt tensioner in a 2004 freestar
First get the new part and also a new belt.,small tube of blue lok-tight..Use safety glasses and work on cold engine..You can also disconnect negative cable from battery for safety in case you drop a tool on alternator and create an arc that could blow a fuse or worse..set parking brake and in park...Look at belt configuration and draw your own picture of the routing...However you should have a small sticker under hood that shows you the correct routing...You will need a good long slim Ratchet to remove belt and tensioner.also regular socket set with short well metric sockets..They make a special slim tool to remove and install belt..It makes it a lot easier...Remove belt...,remove tensioner...Pay close attention how tensioner sets in place..Install new tensioner in same position..use blue lok-tight on bolt threads to mount tensioner..torque it tight but not too tight,,.Install new belt.,Make positively sure belt sits in all grooves of all pulleys while routing..Double check routing again to make sure belt is perfectly set in all pulleys..Tug on belt with hand to make sure all is good and fit....Make sure all tools are removed from under hood before starting engine .......Start engine to verify all is correct...
2/1/2015 3:56:45 PM •
2004 Ford...
•
Answered
on Feb 01, 2015
Computer replacement
Knowing the car type would help.
If it is a GM when you buy a new computer it does not come with the Eprom chips. you have to take the chips out of your old computer and install them in the new computer through the access plate.
If you bought a new computer that came with the chips. You have to take the computer to a GM shop and have it programed to the car that you are putting it in. Have the Vin number with you when you take it to them or they won't be able to program it.
1/26/2015 2:40:14 AM •
2004 Ford...
•
Answered
on Jan 26, 2015
Not finding what you are looking for?