20 Most Recent 1997 Oldsmobile LSS - Page 4 Questions & Answers

1st you will have to remove the belt, and where the tensioner is located , then take the proper size socket , most of the time, it will be a 14 - 15 metric size socket, and a ratchet, or wrench that is same metric size, and hold back onto the tensioner to relieve the tension to get the belt off, and then unbolt the pully, after you bolt on the new pully, then re route the belt back on to the pulleys, according to the diagram that you should have located under the hood on your car.

the best thing to do is stop by a oil change place and they can show you also give these websites a try www.alldatadiy.com and www.autozone.com wish you the best of luck Michigan Man.

VACUUM LINE BAD OR ACCUMALATOR BAD

I THINK IT IS IN UNDER HOOD ELECTRIC CENTER / REMOVE PANEL THEN REMOVE
SMALL COVER (2 OF THEM) LOOK ON INSIDE OF COVER FOR LOCATION
REMOVE CONNECTOR LOCK TAB AND UNHOOK RELAY

the proper fuel preasure should be at least bettween 48 and 55 psi. hope this helps.

is your water pump on that side? if so i would say your water pump is bad.

it is behind the alternator... when facing the car it is the far back left hand side of the motor UNDER the alternator!

WELL BEST TO TAKE TRANSMISSION SHOP LET THEM FLUSH OUT THE OLD FLUID AND PUT IN NEW FLUID.

harmonic balancer, should be able to remove bolt and pull it off by hand was not a pressed pulley for the 3800 series 2

front door 6.5 inch
rear deck...same
rear door 4 inch

your flood doors are locked, cable actuated or electronic actuated if car has electronic climate control. solution replace flood door cables and make sure no dirt or debris is causing them the stick.

depending on the rating of the thermostat install in the engine will determine the temperature range
the factory uses a 195 degree thermostat

Most air shocks have fittings that are also used on your car tires. If it has a similar fitting, it will more than likely fit.

maybe cracked spark plug porcelin when the center electrode heats up it expands leaving a gap to arc out of time for a tune up

no there is not .take the tank down carefully and pour into pails or use a siphon to remove fuel

If your car has a chip in the key, then this is the definitive solution: http://newrockies.com/vatsbypass . It was the only thing that saved my Park Avenue.

The blower motor resistor gets really hot so it is located where the blower motor fan can keep it cool. Look under the hood close to the blower motor.