20 Most Recent 2008 Ford Taurus Sedan Questions & Answers

do you have to take the panel off to replace it

most manufacturers recommend a timing belt change at 100.00 klms as this is the optimum period that the belt manufactures warrant their product for there are factors that will reduce this period such as continued high rpms, dusty conditions, idler bearing failure and oil leaks Oil is the biggest destroyer of rubber timing belts and it comes from cam shaft seals , hydraulic belt tensioner leaks and crank shaft seals basically if you keep an eye on the cover and look for oil and dust marks then any time after 90.000 klms would be an ideal time to consider the belt change

Dealerships will typically help with this.

Usually is on a cable on the factory lug wrench in the trunk.

clock wise is thw answer

its behind the fuse panel on the driver side below the brake pedal, its 2 screws that u will have to take off, u either use ur phone with the flash on to record it, or pull the sticker off, but be careful not to rip it

A clicking noise is a indicator that the starter is bad,to check,you will need to remove and take to Autozone or other auto parts store to test,it's free and only takes a few minutes.Here's how to remove.

Code must be entered in cd player radio as it may be in theft lock mode because battery power was lost, and computer shut it down.

the screws are usually above the light housings

Loading Data
Please wait...

The speedometer on a Ford Taurus is controlled by a sensor in the transmission. The most likely causes of it not working is the failure of the sensor or the sensor coming unplugged. In either case it is an easy fix. Have your mechanic check whether the sensor has failed or come unplugged. good-day ! Check your fuses also,

the floor carpet right ???

1.) remove the seats (they are bolted under)
2.) remove the center console, bolted from the sides and pry up center tray to expose screws.
3.) remove side panels by the doors, it just screws in place.
4.) PULL the carpet out, its tuck using S-Guard so use dome force. remember to put more S-Guard or sealer when putting in new carpet.