20 Most Recent 2008 Peugeot 308 1.4 Questions & Answers

After starting cold does it continue to run properly as long as you want? Is fuel mileage normal? If not, could be bad coolant temp sensor failing to tell ECU engine is warm, such that it is flooding when trying to start hot.

I'm guessing this is a garage job (one with a diagnostic computer that can read Peugeot ECU)

The code is listed as Wiring, alternator, battery discharged, multifunction control module for a 307/407 (see link below:) PEUGEOT 307 407 807 FaultCodes 0601 There is very little information for your particular model. Though I would suspect it is the same fault. Check all cables to and from the alternator for burning or damage/corrosion. Make sure they are clean and tight. If the car still doesn't start, try disconnecting the cables from the rear of the alternator and then try starting it. However, it may relate to a poor signal to/from the injectors. Try cleaning the electrical connectors on the injectors and make sure any earth wires aren't corroded and are securely tightened. You can try disconnecting your battery at the positive terminal for 30 minutes (but remember you will probably lose your radio code..).

Check thermostat ,could be stack close.check coolant level and water pump.

Any non-standard additions such as amplifiers? If so, it may be an installation issue. If that is not the case, could be a "connection issue" or a bad alternator (in spite of some indication it is fine). A multitude of devices tap the battery, brake lights, the light in the cab that you can manually set to "always on", etc.. http://askville.amazon.com/battery-alternator-draining/AnswerViewer.do?requestId=89630481

Hi Ironfist, thanks for your answer but the pictures don't look like the recommended filters. Can you send me a link to your PDF file? Thanks again. My email is [email protected]

Its a belt! See this: http://www.peugeotlogic.com/workshop/base/main.htm

Its a belt! The info is here: http://www.peugeotlogic.com/workshop/base/main.htm

The radiator fan doesn't work , the problem may be or the fan itself , or the sernzor that activates the fan or poor contact at the senzor