20 Most Recent
John Deere 2007 Gator XUV 4x4 620i Questions & Answers
Won't crank
if battery is good, check to see if you have voltage at solenoid. if you do, turn key to start, that should throw the fire from other side of solenoid to starter. if there is no fire on the other side of solenoid when you turn the key,then your solenoid is most likely bad.
John Deere Gator
check your gas tank screw on cap......if there is a breather hose coming out of the cap....make sure the hose is not kinked thus causing a vapor lock in the tank
Rsx 850i wiring diagram
hope this helps
see this link
http://www.gatorforums.net/forum/attachments/gator-performance-modifications/469d1398005196-825i-brake-pedal-start-mod-20140416_191525.jpg
Starter engages momentarily then just clicks
Verify all cables are tight and not grounding out due to broken casing.
Check the relay to the starter, it could be failing. Check that the starter is in good working order by passing current directly through it while its removed from the bike. Put a voltometer on the battery and check that its at full capacity ( volts and amps )
Make sure you have a secure ground to the starter and the battery.
Check the start button for continuity.
Good Luck.
Assembly diagram for a recoil on a 1999 Polaris 400 xplorer
Assembling a recoil system on a Polaris 400 Xplorer involves several steps. While I can't provide an actual diagram here, I can outline the general steps involved in assembling a recoil system:
- Preparation: Ensure you have all the necessary parts for the recoil assembly including the recoil starter, recoil housing, recoil spring, and any other associated parts.
- Mounting the Recoil Housing: Begin by mounting the recoil housing onto the engine. It typically bolts onto the engine casing.
- Inserting the Recoil Starter: Place the recoil starter mechanism into the recoil housing. It usually fits into grooves or mounts within the housing.
- Attaching the Recoil Spring: Connect one end of the recoil spring to the recoil starter mechanism and the other end to a fixed point within the recoil housing. This provides the tension necessary for the recoil starter to function properly.
- Installing the Pull Cord: Thread the pull cord through the hole in the recoil starter mechanism and tie a knot at the end to secure it. Wind the pull cord around the recoil starter as per the manufacturer's instructions.
- Testing: Before completely sealing the recoil housing, give the recoil starter a few pulls to ensure it functions smoothly and retracts properly.
- Final Assembly: Once you're satisfied with the recoil assembly, bolt down any remaining covers or components to secure the recoil system in place.
Always consult the specific service manual for your Polaris 400 Xplorer for detailed instructions and diagrams tailored to your exact model. Additionally, if you're unsure about any step, it's best to seek assistance from a professional mechanic or someone experienced with small engine repair.
4/20/2024 12:13:30 PM •
ATVs
•
Answered
on Apr 20, 2024
Can't find how to trouble shot the horn on my 2015 Kawasaki mule
take off the horn unit power it direct if it works its ok, if not replace, next step wire a small bulb into the horn wires and press the button if it lights the switch is ok, if you have a circuit tester put one end on the battery ground and check for power in the horn wires if their is power there put the lead on battery positive and press the horn button if there is no power their the switch or wiring is faulty
4/16/2024 10:19:40 PM •
ATVs
•
Answered
on Apr 16, 2024
Not finding what you are looking for?
