Level 9 Sound Designs Audio Players & Recorders - Recent Questions, Troubleshooting & Support
I have a 2002 Pontiac Grand Am with a Monsoon
You must remove the radio and then take the chassis apart and replace the tiny bulb that is hard wired to the front of the circuit board behind the display. Tools need are common hand tools a small low temp soldering pencil and a solder suction gun.
Looking for a control pod.
I recently had a similar problem. In my case the left speaker had no sound. Finally traced the problem to a broken wire inside the control pod plug, which I destroyed by dissecting it. For those who have the experience, or know someone who does, purchase a new plug, which a Mini DIN 8 pin (RS-422 standard). It should be available at any good electronic parts store. Solder new plug on to cable, which requires a fine electronic soldering iron and a fair bit of skill (the wires are very fine).
Look at the plug (from the rear); you will see it comprises a top row of 3 pins equaly spaced; a middle row of 3 pins (there is room for 4 pins but one pin is missing just left of centre); a bottom row of 2 pins. I numbered these as follows:
8 o 7 o 6 o
5 o 4 o 3 o
2 o 1 o
The wire from the controller comprises 8 coloured cores and a bare core. The wiring of the eight cores are as follows:
DIN CORE PCB
pin 8 - brown 8
pin 7 - red 7
pin 6 - orange 6
pin 5 - yellow 5
pin 4 - green 4
pin 3 - blue 3
pin 2 - white 2
pin 1 - black 9
body clamp - bare wire - G
In case your coloured cores vary from mine I have also listed the pin each one goes to on the printed circuit board plug, which will let you identify the colours.
Level 9 Sound Designs MH-500 Computer Speakers buzzing
I think after reading your question that your speakers cable may be short or join another line. As a result, it become earthing & create noise. So you can test it by a Multimeter. The multimeter indicator point place on X10 or X100. Then you can understand where the problem in your speakers line. thanks
I have a Monsoon Planarmedia
We are a technical support site, we have no parts reference books or resources, suggest you contact the maker of the system or try radio shack.
I can not get sound to come out
you need to install a driver for it, if it came with a disc install it, if it didnt look up your product and look for drivers or type (your product)drivers in google
Is there a fuse for the monsoon planar 9 as my
Yes, there is. Open up the back of the sub. There is a 250 V 6.3 A fuse next to the transformer. It is likely blown. Remove the fuse and check it with a meter. Replace with similar fuse.
Not finding what you are looking for?