Klimaire Heating & Cooling - Recent Questions, Troubleshooting & Support
What does H1 mean on display
Hi my window kelvinator air-conditioning is coming up hi or h1 when I have it on heater mode I'm worried something is wrong it's only a few months old is that normal
P6 and P4 error messages
P6, High temperature protection of condenser. P4 Ipm module protection. something is wired up wrong or bad connection. here is a site with the wiring diagram. aitons.com
Fan will only blow on low when heat is on
your fan most likely is wired for low speed for heat which is common. this should be determined when furnace is set up properly. motors that aren't modulating motors and are multispeed motors typically have low medium and high taps that come off the motor and go to the corresponding relay on the board. low and medium speeds are used for heat and high and medium speeds are used for cooling. but only one speed for heat and one speed for cooling many times medium never gets used. im not familiar with klimaire is this a mini split system and not a regular air handler. cause speed control should be adjustable from the remote. if its a split but if not reaching desired speed due to a malfunction in the units could cause it to run low speed just to maintain the temperature exiting the indoor unit.
Heater is not turning on
If it is a heat pump as you said there is no glow plug. Check for a high pressure cut-out switch and reset it will prevent the condensing unit from starting. Also with the unit calling to run listen to the condenser for a slight buzzing that may indicate the either the fuse in the disconnect is blown or the circuit breaker is tripped. Even if the circuit breaker appears to be on it may still be tripped make sure to switch it to off then back on, good luck
Not finding what you are looking for?