Questions & Answers for: GAS wire a ballast

how to install HID to honda xrm 125 bought a new hid light i don't know how to install it.need help!!!! Did you buy a HID bulb or did you buy the kit with the ballast etc? Usually an HID lamp will ...

how do i know if i blew a head gasket. started bike let idle then hit the gas it backfired the sounded like an exhaust leak from the left cylinder Bet money your plug wires are switched around. Oil ...

have 1987 340 enticer probly sat for 10 years cleaned carb had it running but bogs out when i gas on it cleaned carb n new plugs fuel lines repaired some wires mice got Set the carb back to factory ...

...Hi Robert: Have you checked the spark at the plug gap by removing the plug, connecting the plug wire, holding the plug against the head, and spinning the motor over? (And avoiding giving yourself ...

...motor if I have a cylinder cap that holds two spark plugs do I need to cdi's? and if so how do I wire it? parallel or in series with my Magneto the purpose of the two plugs was to have a spare

...but when the gas tank is plugged in oil light stays on? Any ideas also if I connect green gas tank wire the starter engages on its own.how do I fix this? Sounds like it is time to adjust your

...bottle while cranking. Pour a few drops of fuel into in sparkplug hole reinsert the plug and plug wire to plug hook fuel line back to tank and carb turn on ignition and crank in neutral of

i have 2006 gsxr 1000 turns over no gas gets past in jectors when take off fule line gas sprays out back ay me check injector control , replace the ECM , check fuse for injector and check wiring and ...

back fire from pipes and carb fire shoots out of both when i give it gas , but ideles great recheck firing order indicates 2 wires crossed

I have a 2015 Thor windsport motorhome that has a Cummins Onan RV QG 5500 gasoline generator, the generator turns over fine but doesn't start. It is getting gas to the carburetor. Is there a kill ...