Questions & Answers for: wd40 house

Question about Luminova 40114675 (675 x 114mm) Telescope

2 Answers

house and spay some wd40 on it.no keep in mind. DO NOT SPRAY ALOT OR ON TO THE LENS OR MIRROR. let it sit for about 20 min then Gently turn the knobs. Make sure you wipe off ant accesive wd40 from it.

Ad

I cannot get the old blinker bulb out of the housing on my 2003 ford focus wagon. Can I use wd40 to loosen it?? help... I would not use WD40 for this - instead use pliers to pull the bulb out. Since ...

Ad

...like the switch has stuck in the fuel cap... clean around inside the fuel cap housing, use some wd40 on a cloth to get the gunk out of the nooks and crannies then operate the cap opener lever

...housing and inspect the unit to determine the problem. before you take it to bits try a splosh of wd40 in the motor the bearings are likely to be sezed up thats all and wd40 wont hurt the motor ...

Question about Ball DC24 Bagless Upright Vacuum

1 Answer

...end of the brush there are two hard rubber retainers that hold the brush in the housing. Add some WD40 between these retainers and the brush, rotate to be sure the WD40 is worked in so that the ...

Question about Cultivator

1 Answer

...it did the same thing I removed the starter housing assembly and sprayed the inside with a lot of WD40 and worked it around and manualy rewound the cord by sticking a small skinny screw driver into ...

Question about Cultivator

2 Answers

...WD40 will attract dust and gum up the cylinder worse. I would recommend using a graphite lube instead. If it continues to be a problem, I would recommend replacing the cylinder. You can find them ...

Question about Cultivator

1 Answer

...goin out i need to change out my care bearing on 2005 Remove the drive shaft from the truck. Using WD40 or PB blaster lube the bearing shaft and bearing housing. Allow it to soak for 20 minutes. ...

The fan is making a rattling noise how do we stop this Rubber dampners could be broken. Spray wd40 on bushings for a fast try to fix. Maybe the bearing is gone in the motor? Put sewing machine oil or ...

...when the dryer was activated. I had sprayed the metal frame to which the element is mounted with WD40 to allow the frame to slide in to the housing easier. the wd40 needed to burn off and it

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Optics Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66974 Answers

Tony Parsons
Tony Parsons

Level 3 Expert

6405 Answers

Are you an Optics Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...