Question about Fan Company 5/1/1 Programmable Thermostat
...thermostat and the heater is not working. Did we connect the wrong wires? The one that came out was an old Robert Shaw that didn't even have the same letter coded wires as the new one. Two questions ...
Question about Electronic Programmable Heat/Cool Thermostat - CT3300A100 Heater
...color of wires connected. Y - Yellow, R - Red, W - White, G - Green, 4 - Blue. The new programmable thermostat is a Honeywell - RTH230B with the following terminals. Rh, Rc, W, Y, G. Are the Y, W and ...
Question about Fan Company 5/1/1 Programmable Thermostat
...color coded. (Ex: attach green wire to where it says GRN on back of base plate). Make sure the thermostat that you are replacing and the new thermostat are similiar in shape, otherwise you will have ...
Question about Fan Company 5/1/1 Programmable Thermostat
...to a circuit board that are also mark with the same color codes. If so, then you just have to make sure that the w on the board is the same color has the w on the thermostat and etc. Hope this
Question about Focus 6300B 5-2 Days Programmable Thermostat Heater
...color code written on the back of the thermostat and the furnace wires were not touched the colored wires each mean something. A simple thermostat swap and matching the colored wires with the labeled ...
...color code the wires to the thermostat. The thermostat should have the colors labeled R,W1,G,Y,B or C for common if it's wired correctly at the Air Handler or evaporator. The blue wire should go ...
thermostat for an electric heater? It is single strand copper wire, it comes as a color coded one piece wire bundle with up to 5 wire strands of different colors, it is available at any hardware store
Question about Fan Company 5/1/1 Programmable Thermostat
...thermostat? If you are unsure about which wire goes where, that may be the source of your problem. The color coding can be confusing when changing from old to new. I pulled the instructions for my ...
Question about EW7507EK Oil Radiator
...carefully on the board itself. Sometimes the wire color codes are labeled right next to the connector. If not, there may be some other letter codes and these should match the ones on the
...the looks of that wiring someone was not following the color code, So following the code may not help unless there are marks on the
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions