Questions & Answers for: suck air bulb primer

...hs 45 hedge trimmer primer bulb will not **** gas into it when pressing trace the llines from the primer bulb and check them for leake it is sucking air from somewhere either the lines or the ...

...bulb while running it is fine upon advancing throttle. I have the same problem and may have a solution. I looked at the primer pump and it was cracked letting air into the system. When I pumped it my ...

...The fuel is not being sucked in to engine. Check the needle and seat to make sure fuel is flowing in to the carburetor. the primer bulb has hair line crack in it sucking air rebuild carb and a new ...

...and the prime bubble wont fill Sounds like you have an air leak. Either in the primer bulb is split or punctured, hole or leaking fuel line or primer bulb base, and is sucking air instead of

vapor lock on Mantis No gas in primer bulb check the fuel lines for a breakage or the primer bulb for a crack. Sounds like it is sucking air instead of fuel

...shape instantly its sucking air. Also check for cracked fuel line which will also cause air to be sucked in and not fuel. clogged primer your going to have to rebuild carb and install new primer ...

...into the carburetor. Could also be the opening into the carburetor from the prime bulb is blocked. leaking primer tubes or primer the tubes when leaking do not have to spew fuel, rather they suck ...

...bulb sucks (pulls) the air fuel through the carburetor thus venting out any air. The process draws the fuel through the in tank filter through the impulse fuel pump. The fuel connects via an internal ...

...bulb and fuel lines. Its not un common to have air in the primer bulb, Check for a possible air leak in the system. This will make the saw idle higher than normal if its sucking air from

...air in gas tank,but wont pull gas into carb. 25cc craftsman You need to replace the primer bulb. Also check that you have it the right way around, one tube sucks, and the other tube blows. The primer ...