Questions & Answers for: restart neptune dryer

...neptune. I set it on sensor dry and start the machine. After a while the display will read (instead of the time) a rotating rectangle. It will shut off and restart automatically. I believe that it is ...

...neptune dryer wont restart mde 3000 aya my maytag neptune dryer will not restart after the first load has dryed and a new load is immediately loaded. I have replaced the hose, cleaned the lint trap ...

...restart dryer We changed propane companies so source was temporarily shut off while tanks were changed. This was done while no one was at home so they could not relight pilot/igniter. How do we ...

...Neptune MDG 5500 AWQ heats sporatically Dryer will run and dry normally. Then it will not dry. Took off front panel to inspect...observe igniter...did not glow. Unplugged dryer, waited 1min, plugged ...

neptune dryer mde5500ayq replaced old motor with new motor starts up first time alright I turn off and it will hesitate to restart. most times it will not restart. Humms then kicks out. I have no belt

Neptune model MDE9700AYW dryer that wont start I had a small load of clothes including a pair of tennis shoes in it. The shoes knocked the door open, so I took them out and tried to restart the dryer.

neptune mdg3000aww starts heating and runs fine but stops heating shortly after start up can restart heater starts again and shuts down If the machine keeps running but just not heating you have a ...

restart right away. Dryer shuts off on own. Can't restart right away. Will start up again after a few minutes. What is the problem you think? if it is electronic activated(push bottom with digital lcd

...Neptune Dryer ran for about 10 minutes, and then stopped. Nothing was on the display panel when it shut off. There was a very strong "burned electrical insulation" smell. The clothes were still damp, ...

dryer runs 20 mins, stops, must be restarted over and over. run time becomes less and less after each restart. I disconnected vent or problem continues. I replaced motor 3years ago. I installed unit ...