Questions & Answers for: repair plastic clutch line

...plastic cover. does this fluid tube come off and if so How? the whole assembly is over 275 dollars canadian and i would rather just replace or repair the hose. thanks easist fix is to visit a car ...

Ad

Question about 1991 Legend

1 Answer

...repair at no charge. I am assuming you have never installed a clutch before. What you are asking about is a clutch alignment tool. It is a tool made from plastic that is identical to the output shaft ...

Ad

Question about 2003 TrailBlazer

2 Answers

...repair or where to begin SOMETIMES THE WIRING HARNESS GET DAMAGED WHEN FAN REMOVED. GM HAS BULLETIN TO REPLACE COOLING FAN WIRING HARNESS PART# 89024920 Harness Assembly, Engine Cooling Fan Wiring ...

...near the brake and clutch fluid reservoirs. Follow the fuel line going to the carb or the line coming from the gas tank. Some are clear plastic, some are white plastic, a few might have a metal

...plastic and its cracked on the bottom about half-way to the firewall. Yes it is a bear to replace and no you can`t repair it effectively the pipe goes to the clutch master cylinder above the

...plastic tubing of the hydraulic clutch line. This is the section between the reservoir and the braided line into the tranny. Truck is 2000 S-10. What is the best way to repair this without replacing ...

...plastic piece to the three un-used holes in the rubber piece. If they don't line up right, the coupler could be damaged. Mount the motor, don't forget the two screws, put the pump back on the motor ...

Question about 1997 Cavalier

1 Answer

...plastic container just like your brake fluid reservoir. Check the level. If it's to low or leaking. Repair the leak (exactly the same as a brake line) and bleed the line. You bleed the line by ...

...Repair manual on your vehicle. This is for clutch systems that have no bleed screws or theaded fittings. That is snap fit hydrolic lines. Thus works best with a new slave cylinder, but with some ...

Question about 1998 Pickup

1 Answer

plastic reservoir very near brake booster) for fluid level. If low, fill to line. If empty, you might have air in the system. Not sure on your vehicle, but sometimes you can adjust the rod that pushes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Optics Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66979 Answers

Tony Parsons
Tony Parsons

Level 3 Expert

6405 Answers

Are you an Optics Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...