Questions & Answers for: poulan wild thing 2375 carburetor

setting the carb twe jets These people explain better than anyone else I have found. The sound files are very helpful too. Carburetor Adjustment by Madsens.com ...

...Poulan Wild thing 2375 Start at 1.5 CCW from lightly seated then tune for performance like this: Carburetor Adjustment by Madsens.com http://www.madsens1.com/saw%20carb%20tune.htm CW is leaner; to ...

...2375 chainsaw will not start for me. Turn it to on position, prime it, pull out choke and pull three times, pull till brain cramps and arm aches and nothing happens. Any suggestions before I get out ...

poulan 2375 carburetor adjustment, please explian red abd blue adjustments and procedure Blue = "L"ow, Red = "H"igh If running just do the following: Carburetor Adjustment by Madsens.com ...

...Poulan 18in. wild thing chain saw? "L", "H", and "T" adjustments are all explained on the link. It is a very good carburetor setting procedure. Start with ?L? & ?H? needle valves 1.5 CCW from ...

...poulan 2450 chainsaw and i can't get the primer bulb to **** any gas, the bulb is in good condition however there is gas leaking out of the gas cap in the center of it, do I need a new gas cap and ...

its hard to start then when its running as long as you keep it wide open it runs if you let off it stalls and is hard to start again if it does The engine is starving for fuel--check the fuel filter ...

Wild thing chainsaw won't stay running. I replaced all fuel lines, primer bulb, fuel filter, gaskets to the carb. and have cleaned the carb out very well and blew out all passages. I pulled the ...

polan 2450 chainsaw will not start when cooler that 60f degrees. Check the plug and clean if needed. Prime with 1 teaspoon of gas or starting fluid into the cylinder through plug hole, replace plug ...

only run with choke on guess you need to clean the carburetor and air filter .