Questions & Answers for: how to use a pop rivet gun

...pop rivet gun with steel rivets when reassembling the housings. Frequently these rivets get loose, & need drilled out & changed. I am assuming that the rivet holes in the housing are not elongated or ...

...or is the question how do you reattach them? You can reattach them with pop rivets and a pop rivet gun. Screws might work, but sometimes screws protrude too far in and get in the way of moving

...I used bolts to put the motor back on the arm, but had to buy the big pop rivets and a big pop rivet gun to put the door back together.. All in all a big PIA.. I would take it to a shop..

pop rivet gun?). Charlie Yes they are rivited. You need to remove them, and replace the rivits with new ones. No one said this was easy. Drill out the head of the rivit with a larger drill bit, untill

...motor wire harness - drill rivets from from motor mount - install new motor with pop rivets (need a gun) or screws - etc. If you need more info on how to do these things, let me know. ...

...pop rivet guns because the rivets are 1/4 ones. also, when you go to rivet the handle back on, tape some cardboard under the handle. that way if the rivet gun drops after it snaps off the rivet, it ...

...pop rivet the new one in place, this requires a special jumbo size river gun and a rivet head cutting tool. Its is possible maintenance problem (first step easy); the next step is check if the power ...

a pop rivet gun all can be purchased atb Ace Hardware...reinstall the reverse of dismantle proceedure and happy mowing...don't forget to attach the black plastic/rubber pull cord handle. Happy Mowing!

...pop rivet gun just to open it.  Try spraying silicon spay in to the inside of the handle where ever can then pull up ******* the release buttons while flexing the joint back and

...w/ a pop rivet gun.The claws that do the grabbing are stamped,labeled (L)-(R). Reassembling the Grabber w/ the rivet gun wouldn't be too difficult .I could fix your problem, if we were