Questions & Answers for: Abit monitor wont stay on

monitor wont come out of standby The PC was working correctly, than the other day i was upgrading windows and i lost power, when i rebooted it jus stays in standby, i can see the fans and hear my ...

...monitor and if you leave for a couple of days it will go back on again for lyk half an hour then turn of and wont start up again The problem is ***********, there is electrolytic capacitor leaky ...

a17 wont boot i cannot get my monitor to work on boot coming up with code af ok what board is it #then check the manual for error post code error af if not try another card liek a pci one or agp one

COMPUTER WON'T BOOT UP I turn on the computer,the hard drives run but there is no signal to the monitor. I replaced the viedo card with a new one,checked the memory to make sure it was conected solid&

...monitor wont display anything Abit IS7-E2 fitted motherboard all done right, but vcc red light is on and monitor wont display enything help is this a brand new motherboard? do you have onboard ...

...monitor wont boot or display anything, no signal. so i removed the hard drive. everythings the same, fans running, no beep, the power light is on except that after like 5 secs it will shutoff and ...

Won't Recognize Monotor I have a Abit NF-M2S motherboard. The motherboard won't connect to the monitor. The light stays amber. Help? There should be a jumper inside your computer that resets the bios,

No signal from monitor, help! I have no signal on my monitor and my pc is not running do u have a video card? or your monitor in connected in tou integrated grapics port? (i.e. in *********** board.) ...

...wont show anything on the monitor though the cpu fans are running..and there's no disk activity until i unplug the ide cable... Remove the memory from the slot near to the fan and place it to the ...

...stay on but it wont power up at all. if i turn the power off and on again it does the same. if i just try turning it on again without swiching the power it does nothing. ive tried disconecting ...