Questions & Answers for: miller cutmate 375

cup light is on machine will not work is the cup the glass container how do you reset The cup light is referring to the outer most part on the torch tip, the purpose of the cup is to create a gap ...

...miller spectru 375 cutmate? When wiring a new plug for which voltage input? The cutter has a white wire, a black wire, and a green one - white is the neutral line, black is the hot line, green is ...

Miller Spectrum 375 problem My plasma cutter just shut off and now nothing happens when I try to turn it on. It was only on for about 30 seconds when it quit and no cuts had been made so it was cold. ...

When pushing trigger it starts then stops quickly Snap On Plasma A25 Its brand new, I have use it just a couple of times. When pushing trigger it starts then stops quickly or makes a clunk and stops. ...

how hard is it to change out the main circuit board on a spectrum 375 plasma cutter? What is the cost of the board? The replacement of a board is no TOO hard, just DRAW a Diagram of ALL connections ...

all lights correct, no start Spectrum 300. All conditions appear to be right. When the torch button is pushed, nothing happens. loosen the retainer cap and twist the consumables and retighten

...do that it will not cut continusle please advise does not matter where the temp is set thanks rex miller You may need a better air supply. Also check the tip. This sometimes happens with mine when ...

green light flashes always remember the ground...have a big air supply. small compressors can not keep up and machine stops cutting.

spectrum thunder plasma cutter will not cut steady, keeps stopping and have to pull trigger to cut Check the contactor contacts for pitting. if severly pitted, replace contactor.  If a death grip

esab plasma cutter fault light comes on as soon as it is turned on The cable or  cutting head may be damaged.  The power connections may be loose, an internal circuit breaker may have failed