Questions & Answers for: lo humidity

...letters LO appear instead of the existing humidity. Nothing in the instructions about this. The LO wont go away I have the same problem. And nothing in the instructions. Searching for a solution

...to a reasonable valve. Frost on coils usually will appear. I would imaging that the humidity is already lower than the dehumidifier could get it down to. that's why it reads "Lo" on the

lo and it runs. If you're setting the humidity level on 70 % , that means you want to leave the relative humidity in the house at 70%. That's why the dehumidifier is cutting off. Your house is

...Lo" reading at humidity setting "Lo" reading at humidity setting Dont spend to much time trying to repair dehumidifier they are very cheap to replace. Most dehumidifiers have lots of ...

...'LO' show up. What does the 'LO' code mean? Hi, it simply means that the humidity level is lower then 35% the lowest setting on the dehumidifier... It will not run when showing

...humidity above "LO" = 30% at this time. Once it the humidity level rises above 30%, it should turn ON and function normally. Also, was the timer set to turn the unit OFF at a specific time? If the ...

...humidity % registers 70 but in just a minute or 2 it begis to decline and ends up at Lo which then wont pull water from the air. I know it is humid, some sensor must be getting fouled up. 70% is not ...

...LO The humidity display window always shows LO. I thought over the winter it was because it was so cold and the humidity was very low, so we turned it off until spring. It should not be too low now, ...

but still shows temp and humidity? I may have reached the humidity level that you have set it at. Press the HUMIDITY button until it says "Lo". That should put you into continuous run mode. Good Luck

humidity at 50%. it consistently turned itself off. Ok on 35 and Lo. there is a sensor in the unit much like a temp sensor, (bullet shape) over time these do ware out and need to be replaced this tell