Questions & Answers for: high pressure washer stalls

high pressure washing, the engine dies. The engine requires more fuel at higher loads. If unit sat up for some time the jets in carbureator may have become partially plugged due to varnishing. If this

...high pressure nozzel engine quits when I let go of the wand trigger. Found O-Ring on caberator bowl dammaged. PRESSURE CONTROL WOUND DOWN TOO FAR CAUSING IT TO SPIKE....WHEN YUO RELEASE TRIGGER ...

...high ,if you back the pressure off abit you will solve the problem. if your machine has a pressure gauge ,you will be able to see the pressure needle"spike" when you release the trigger.that is the ...

...build up. If it sticks open, the washer will stall. Most other problems are engine problems due to bad gas, carbureator, etc. the pressure is set too high -----back off the unloader valve a turn or ...

...high, the unloader must open in odrder to cycle water back to inlet side of pump - if not builds up heaps of pressure , stalls the engine - service the un loader valves on the pressure head take look ...

...to spray By stalling you mean quit or bogs down until you release spray? The engine has to be on high speed and be in good tune with good gas to produced the horse power for the pump. A too small ...

...high pressure. In fact when I pull back on the wand nozzle to activate the high pressure the engine usually stalls. Help! run the water engine off pull trigger be sure to get all air out thats what ...

...high pressure nozzle but when I switch it off i see that the water path through the PW is not blockedas stated above i made sure that NO air was in the system PLEASE HELP THANKS The unloader on your ...

pressure is on high. It was working fine for about 1/2 an hour then stopped. From what i understand ,you might have a bad armature Armature partly dammed it can work for a while then will stop when it

high pressure output port where you connect your hose and trigger gun remove the fitting inspect check valve it may be stuck open Frank, either the unloader valve is out of adjustment(try loosening it