don't know how handy you are with electricity, but I would disconnect your main service and pull out the GFCI breaker and check for any shorts or problems on the circuit before I replace it. Good luck
Question about 1 30 Amp Ground Fault Circuit Breaker
...breaker tripped. Hopefully your panel is labeled (or it should be) Are you saying this tripped while using the extension cord? Another possibility is that it is controlled by a GFCI outlet. You can ...
Question about 20Amp 1-pole arc-fault circuit breaker
...about 10 seconds or so. If the breaker is wired incorrectly or there is a fault in the circuit the amber light will stay on. Seimens gfci breaker yellow light is flashing and the outlets are ...
Question about 277W-BOX SINGLE POLE SWITCH & RED NEON PILOT LIGHT
...GFCI: Hot from breaker always connects to brass-colored Line screw Neutral from breaker connects to silver-colored screw that is opposite Line screw. If other switches and plugs are going to be ...
GFCI outlet on it. Trips mabe once a week. replaced the breaker and it worked fine for about a month now its triping again. You should not have multiple GFCI devices in any one circuit. Change out the
Question about CUTLER HAMMER BR4040B200V BREAKER CIRCUIT 40 200 AMP VALUE-PAK
...breaker pannel in my home,came home from work and found that the bathroom light over the shower was dimm, the gfci circuit which controls another light over the sink was tripped.when i reset gfci the ...
Question about 20Amp 1-pole arc-fault circuit breaker
...GFCI breaker and it still won't work. I checked the wiring to the switch with a tester and no light appeared (no power). Suggestions??? Sorry for delay answering, this question appeared today ...
Question about 20Amp 1-pole arc-fault circuit breaker
GFCI closest to the breaker box and work your way down stream.....Verify all breakers are reset. Check all GFCI's everywhere you have one to see if one is tripped. If so .... Reset it. IF not ........
Question about 20Amp 1-pole arc-fault circuit breaker
...breaker and rec.., or replace gfci with another one.is box dry even a small amount of water will cause it to trip. do not float grounds or neutrals, ensure that the black power wire is on the black ...
Question about 20Amp 1-pole arc-fault circuit breaker
...wire and breaker Check if there is a tripped gfci outlet near by. Reset it. Disconnect "load" wires from the gfci outlet and connect them before the gfci, make a pigtail splice, more wire
Usually answered in minutes!
136 Questions
113 Questions
61 Questions