Questions & Answers for: flux core nozzle

...flux core spatters like crazy, and 75/25 has light spatter also If wire feed is to fast the wire will spatter rather than weld and stick.CO2 burns hotter than 75/25cooler,100 even cooler.I find that ...

...nozzle end. dont pull it through with pliers as suggested it will damage the drive mechanism. adjust the feed rate and start a practice weld. check you have the correct wire for the welder( gas free ...

difficulty changing the wire My Century 80 gl wire feed welder will feed the new wire approx 2 ft then willnot come thru the nozzle of the welder. Tyhe wire being used lincoln .035 check the tension ...

i need to know if i can use that 117-021 mig welder with a flux cored wire and no gas? thanks It depends on the model. Some units needing the gas for cooling the nozzle.

...flux core mig welder I have to turn my wire feed all the way on max to get the wire to feed. It seems like to motor is getting weak. Sometimes it seems to work right but only for a few minutes and ...

My C/H Mig. Mo. WG3000 Wire feed will not spool out smoothly, wire jerks when welding is it a Speed control or Drive deck Please help As long as the motor keeps turning fluidly, then the fault lies in

flux welder. I can not get any *********** at all. Has worked fine in past. Am getting gas to the nozzle. Bead looks nice but even with the lightest gage metal, bead just flakes right off. CH had told

...flux core wire welder to use gas for MIG/MAG welding? I have one, and the gun appears to be designed for gas use, with the gas feed holes behind the tip inside the nozzle. But there is no existing ...

...flux core wire, make sure the wire isn't too old and it hasn't been exposed to moisture. If you are using gas, make sure that the gas regulator is working properly. If so, then try getting ...

...flux core to gas on a MIG 135G welder I have had no luck welding with this machine I have looked for some kind of manual for set up as far as polarity goes nothing...Any help would be greatly ...