...pull. I'ts a possibility that the engine has seized, remove the spark plug and look at it it will give you and indication if the engine is burned up. Can the engine be repaired and is this very ...
...pressure on sometimes the float in the carb can stick causing the gas to fill the engine, this will prevent the engine from moving and therefore locking the pull cord. check the oil, is there gas in ...
find problem. I bought a briggs and stratton power washer and the pull cord is stuck how can I fix this? Press on the trigger on the wand to release pressure . then pull on the cord and it should work
...Jon Pull starter rope wheel is Jamming against casing usually some lube n check for ware will fix it Pull cord is completely hard to pull. Pressure washer stopped running and the pull cord is
...fix this? My power washer started doing that after the pull-cord mechanism broke. I took off the hoses to make sure there was no back-pressure caused by the pump. And pull rope was still frozen. We ...
it how do i fix it IF YOU HAVE BEEN USING THE PRESSURE WASHER AND THEN TURNED IT OFF,THERE WILL STILL BE PRESSURE IN THE HOSE.YOU WILL NEED TO SQUEEZE THE TRIGGER ON THE GUN WHILE YOU START THE ENGINE
Question about Maxus Prosumer MX5223 Pressure Washer
...pressure washers are more costly to fix as compared to a new one.. If the pump/engine tipped over, oil could have filled the cylinder. The piston cannot compress the oil and would seem to ...
Question about Lawnmower Hrr216 Hrs216 Hrb216 Recoil Starter
...fix that? Also, the starter cord needs replacing. I carefully unbolted the top, looked around, and put it back on. I need advice. Thanks. You might want to check this forum. How do re wind lawnmower ...
Question about Horizontal Engine 5 HP OHC 3/4 x 2-7/16 GC160-QBC
Is there a how to video, on how to fix pull cord and spring on gc160 honda pressure washer go to YOUTUBE.
Question about Blue Max 2200 High Pressure Gas Power Washer
...pull cord is stuck it might be a simple fix. Did your machine tip over on its side? If it did oil often flows into the cylinder. Just remove the spark plug. The recoil cord should pull easily and oil ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions