...power wire. It will be a thermal fuse that is wrapped in a teflon mesh cover. If there is no fuse, then chances are the unit will be a loss unless you know someone handy in electronics. Dear ...
Question about K2.26 Electric Power Washer
...power washer inlet-outlet manifold cracked along weld water permanently leaking. faulty moulding. well depends did u use it in cold tempatures if so no it was u. if not then most likely or could have ...
Question about Affinity ATF6000ES 3.5 Cu. Ft. I.E.C. Front Loading Washer
...power outage, call electric company. Water supply faucets are not turned on. Turn on water supply faucets. Motor is overheated. Washer motor will stop if it becomes overheated. It will automatically ...
Question about Duet GHW9150P Front Load Washer
...washer was displaying 06 (I think). I tried to reset it and then there was a loud pop and all the lights went off. Now it seems there is no power going to it but at the same time the door is locked ...
Question about Duet GHW9150P Front Load Washer
...power, but start button does nothing. Resetting breaker did not work. Any ideas? Thermal Fuse Item #2986 (OEM Part) $10.70 Thermal fuse. If the dryer overheats, this device stops the flow of ...
Question about Duet GHW9150P Front Load Washer
...electric components. This event tripped ground-fault protector outlet. Later discovered a piece of clothing trapped between agitator and tub. Peculiar behaviors on restarting after unplugging for ...
Question about 16017720 K3.690 X Series 1800 PSI Electric Cold Water Pressure Washer
...power on and it works and then it switches off and will not switch back on until you leave it for period of time and then it powers up again This is an indication that it is overheating in the motor. ...
Question about 16017720 K3.690 X Series 1800 PSI Electric Cold Water Pressure Washer
...washer is working, the pressure does not appear to be high... I am assuming this is electric powered and if so your motor is overheating and cutting out. There are many reasons why this can happen. ...
When the gun is closed...pressure accumulates in the spill valve and it will move to close the electric power. When gun is opened...the pressure is released and the machine starts pumping. Regards, MG
Question about K3.68MR Electric Pressure Washer
power but nothing to the washer you may have a bad power cord test it for proper voltage. , thus it is not getting power to the control board. or some units have a thermal fuse that may have blown see
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions
