Questions & Answers for: drill chuck problems

...while it's on the drill. if you close chuck as you can & see if the jaw are sticking out.use a hammer & tap the chuck jaw, then open & close the chuck do it again x2. remove the screw & there you ...

...chuck. this problem began when the drill was about 3 years old, under light shop use. i replaced the chuck, but the problem continues. this happens with smaller diameter bits. Most chucks have a ...

...fine! Thanks. Steve in Redondo Beach, CA home depot replacement chuck i beleive you can also us a keyless chuck. they usually come with instructions. most have a screw at the inside of drill chuck. ...

...chuck off a makita cordless drill HI, Most hand-held drills have chucks that screw onto the shaft with a right-hand thread. Reversible drills lock the chuck in place with a left-hand threaded screw ...

...Drill DC728. Chuck came out of drill body Dewalt Drill DC728. Chuck came out of drill body with drill bit in chuck. Probably can replace screw in chuck but need to get bit out. Help. I would clamp ...

...chuck is probly missing. replace the ball baering. ball bearing in chuck is sticking spray inside of chuck with wd /check drill bit for wear if still no good replace chuck hopwe this helps merlin ...

...drill chuck with a drill bit inside the chuck. This drill is a Sears 3/8" 31510300 Craftsman. I have used this drill many times without having this problem. I just put mine in reverse and grasp the ...

drill with a 1/4 inch chuck, you would do better to just buy a corded 3/8 drill. But otherwise, yes, change the chuck if you can find one to fit at a reasonable price. Drill chucks are sized to hold a

...drill press the chuck is way off by 1/4" at least. How do i remove the chuck? Is the chuck the problem? look inside the center of the chuck... if the is a bold inside, remove it. then place the short ...

chuck problem chuck will not open If it is a keyless chuck, try resting the chuck on a wooden work bench, and with a dead-blow hammer aka: shot hammer, slant-strike the chuck in the unscrew direction.