clutch My clutch is stuck on the driver setting. I have tried loosening and tightening the keyless chuck several times, but that seems to do nothing yet. HELP!!!! Get a torx bit, either 10 0r 15 & ...
Question about 18 Volt Compact Drill Kit
...Dewalt DC925 cordless drill but I can not remove the old chuck. There is no screw and I tried tightening an allen wrench in the chuck and taping with a hammer. The chuck slips . I am replacing the ...
Question about DC925B Heavy Duty Xrp 18V Cordless Hammerdrill/Drill/Driver Bare Tool
...dewalt dc925 drill on drill mode the tork kicks in meaning when i hit a bit of resistance the chuck stops moving. it works fine for screws and drilling but it wont drill through knots and hardwood ...
Question about Cordless drill/driver kit 9.6 volt 3/8" DW926K - 2
DeWalt cordless drill DW926. I can't get the attachment off that holds screw driver to use a drill bit. Instructions? Turn your drill speed selector to "1" and put drill direction in reverse. Hold the
Question about 18v Battery Hammer Drill Dcd950 Dc925
...loose and the screw bit holder will fall out. I have stopped using this drill since it was too frustrating and I woild like to fix it. I bought it as a tool only for $99 so if fixing it is more than ...
Question about 18v Battery Hammer Drill Dcd950 Dc925
...dewalt dcd970 18v xrp and when i try to unscrew anything the bit comes loose. Can't figure out why? check the inside of the chuck at the bottom(open the chuck to max). There should be small screw ...
Question about 18v Battery Hammer Drill Dcd950 Dc925
dewalt cordless drill, 18v battery. I used a larger diameter bit to drill holes into a couple of wood posts. After this project, I could not get the jaws to release the bit. Finally got it loose using
Question about DC988ka 18 - volt XRP 1/2'' hammerdrill/drill/driver kit
...loose screw. I tapped on the screw using a screwdriver and was able to tighten it a bit thus allowing the jaws to free. I removed the screw, put some thread locker on the threads and reassembled it. ...
Question about DC988ka 18 - volt XRP 1/2'' hammerdrill/drill/driver kit
Dewalt 14.4 Chuck will not open or close The chuck cannot be loosed by hand; it spins but l the plastic grip were it would typically be used to open or close the drill for insert/removal of the bit ...
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions