Questions & Answers for: Cobra how to connect i tunes

148 gtl Placed workman b-100 in attic, I can not tune antenna as swr swings to the right on transmit Hi, It would seem that you posted twice. Here is the link to your other post. If I may add to ...

cobra 29 has bad connection i had my cobra 29 modded and now every 10 to 15 min. the connection doesn"t go out but anyone talking to me or listening to me it sounds like charlie bowns teacher. to it ...

after keying antena lite stays on have to turn radio off to clear Make sure your antenna is tuned properly. The light comes on when the SWR is too high. This damages the final transmission transistor.

swr co phase issue i ve got a cobra 29 thats tweeked and peaked and am trying to get the swr down on a co phase harness with wilson 2000 antanas ther down when im just tuning 1 to were it dosnt move ...

Loss of Signal My radio has been working fine until yesterday. I dont hear anything one minute, i turn it off and back on and hear static signal, when i key the mic and let go, i dont hear anything ...

I can hear people talk but they can't hear me I have a cobra29 nwst what should by settings be at Set the switches to: 1) S/RF, 2) OFF, 3) CB, 4) HI and 5) NOR. You may change any of these to any ...

29 ltd classic won't receive good when switch to Cal or swr an key up meter don't move This could be an antenna related problem. Check the PL-259 connector (spin on antenna connection for antenna coax

keeps blowing in line fuse when i turn it on If your blowing your inline fuse you have a direct short. If someone was in your radio tuning it up then check for a capacitor or resistor or other ...

my swr are high with proper calibration You may need to retune the antenna system if the coax has not been kinked or damaged.  If you simply moved it over from the old rig, the antenna was tuned ...

...need to identify the audio input and output points on the circuit. These are the spots where you'll connect the necessary wires. Once you've identified the right points, you'll need to solder a wire ...