Questions & Answers for: compression husqvarna 350 chainsaw

Husqvarna 350 I set the chainsaw down in the snow while it was running and when I went to pick it up it was shut down. I could not get it started again. Hi An engine needs three things to run(fuel and

husqvarna 350 '' has spark but won't start???????? i have a 350 rancher and it has a good hot spark but won;ty even act like it will pop over even with a spritz of starting fluid?? Did you spray the ...

Husqvarna 350- stopped while cutting The saw was cutting properly and stopped as if the switch had been turned off. Checked sparkplug and had plenty of fire. Appears to be gas problem,possibly caused ...

Husqvarna chain saw not starting. Seems to have lost compression. What should the compression be? If its lost compression i would remove the two/three screws holding the muffler, take a look through ...

saw stalled after last cut,and seems to have lost compression Doesnt sound good, remove the two muffler screws, remove the muffler, check the condition of the piston through the exhaust port, any ...

...husqvarna 350 chainsaw and tighten the 2 washers back on and the chainsaw cuts out. what could be the probelm? It could be the brake has activated, the band is now smaller than the drum, as you ...

...husqvarna 350 that wont start, wondering if anyone can tell me what is the factory compression rating? Hi and welcome to FixYa, I am Kelly You should have 120 PSI or greater compression. There is a ...

...350 chainsaw won't stay running start the saw , runs for a few seconds and stalls There could be a couple of things wrong. Check fuel filter and fuel lines for integrity. Then check air filter. ...

how much compression should the saw have? What Causes Too Much Compression on Poulan Chain ... homeguides.sfgate.com > ... > Other Types of Mortgages Many makes of gasoline-powered yard tools, ...

...husqvarna 350 chainsaw that was running great and it just went dead and now it is popping back through the carb what is wrong with it and how do I fix the problem If its back firing through the carb, ...