Questions & Answers for: check valve replacement 2001 harley

...valve (oppose to the usual manual petcock)6. if it were the MAP sensor, bike wouldn't even run a block away + idling would be rough;7. by chance are you using a Power Commander?Also your post "bike ...

...valve needs cleaning...take it to your trusted mech...Good Luck to you friend...Tim One item you might want to check is for a vacuum leak. All the rubber plugs and stuff on the module sometimes wear ...

...valve standing open even the slightest bit, you're compression will be lowered and a misfire will result. I'd also change the "rubber bands" on the intake. They don't cost much even if you purchase ...

replaced leaking quick connect fuel line now leaks worse Hi Anonymous, for more information on your question please visit the websites below and good luck: Harley Check Valve Rebuild Kit

...check for spark with either a third plug grounded or lift the end of the plug boot 1/2 " off one of spark plugs that are in the head. and the usual suspects are: 1. Fuel tank empty 2. Fuel supply ...

2001 road king is only firing on back cylinder. replaced plugs and coil still the same, what is next? Replaced plugs checked plug wires replace coil and it is still firing on the back cylinder only Hi

valve. 25. Incompatible performance parts. 26. The control module may be in "LIMP" mode 27. Check for engine trouble codes. For more information about your issue and valuable "FREE" downloads that you

...check valve from fuel tank needed replacement. That ended fuel pump sounds. But, thats when the Hiccups and backfires began. Since then, I have replaced the camshafts, Lifters, Pushrods, Cam chain ...

2001 ectraglide standard ticking noise on decel sounds like valves ticking any ideas 63000 miles cam tensioners? Hi Anonymous, your push rods are non adjustable but you do have 4 options: 1. with ...

...check ball stuck. 14. Compression below 75 PSI. 15. A stuck-bent-burnt valve. 16. Improper valve clearance (too tight) 17. Severely discharged or a damaged battery should have 12.5 volts or more and ...