...fuel line with peice of wire with hook on end.if you look in tank you can see line and filter. As a follow-up to my post of my Husky 455 rancher dying when I go to cut, the local repair shop told me ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...fuel line off to see if something is obstructing the line. Also the fuel filter can be changed. If you are not getting spark with the spark plu relace the plug. Also to check the spark, remove the ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...off after about 20-30 seconds. If i prime the gas it starts and shuts off again. Cleaned plug, changed gas and oil mix. See if air cleaner is plugged or needs changed or cleaned I have been ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...ethnol mix in your saw there is a good chance that your fuel vent line is plugged. Loosen your fuel cap and start saw on its side and see if it runs. If it does you will have to clean your fuel
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...change the two jet settings? Put some fuel mix into the plug hole and pull it through--you should get a pop or two. If ok, then concentrate on the fuel problem. If no spark at the plug, check the ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...change, check the fuel filter for plugging and the fuel line that it is attached to for decay or other damage. The fuel line in the tank should be long and flexible enough to allow the filter to flop ...
saw acts like it is not getting enough fuel, i changed fuel filter, there was dust particles in choke are. the carb needs to be cleaned out or you need a carb kit to replace all the gaskets. also ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...new carb no change checked muffler it ok fuel filter fuel line allok Does it have plenty of compression, they are very prone to gummimg the piston ring in if you have been useing a large fuel oil
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...change a fuel filter on a husquavarna 455 rancher Hi Rick, To change the fuel filter: 1. Drain the gas from the tank and run the saw until it is completely out of gas. 2. Remove the top cover. You ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
change the fuel line on a Husqvarna 455 Rancher feed a wire threw the tank cut the new hose down to 1/3 about 1/2'' long slide it over the wire and pull it back till it pops threw then pull it
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions