Questions & Answers for: chainsaw dies pull trigger

pull the trigger to let it idle it dies. If you keep feathering the trigger you can keep it running for the most part. Try adjusting the idle. The will be a couple adjustment screws, there will be an

Chainsaw will start and idle if choke is pulled out, but when choke is pushed in or trigger is pulled to saw (thus deactivating the choke) the chainsaw dies. Let it warm up first ...

...pull the trigger. Even though the rpm never get high enough to properly start moving the chain, there is no sign of movement by the chain whatsoever. Then it starts to smoke and run poorly and then ...

...chainsaw, will cut wood with out pulling trigger. Runs is very vast, dies when pull trigger. I would say it has an air leak, through a gasket or crank seal, make sure the carb is tight and sealing ...

...chainsaw warms up it dies unless I pull on the trigger. How do I adjust the idle I just don't know what screw on the carb orator to adjust and which direction The T is the 'tick over' ...

...pull the trigger it dies it start fine , then i pull the gas switch it dies on me ? Running to lean, replace the fuel filter in the tank, turn the H screw on the carb out 1/4 turn to richen the ...

chain saw not working right chain saw idles when choke is at half way, dies when the trigger is pulled unless you butterfly it Running too lean, replace the fuel filter in the tank as a start.

...chainsaw starts and idles properly. However, when I fully pull the trigger, the engine quickly loses RPMs and will die if I do not let go of the trigger. Spark plug and fuel screen are both OK. What ...

My chainsaw starts and idles fine but when I pull trigger to a point that butterfly opens it bogs down and almost dies. Has fresh fuel Fresh air filter?

...chainsaw will be similar to many small engined tools where owners often discover they need an extra hand. Usually the throttle is opened (trigger pulled) and then the trigger lock is pressed and the ...