Questions & Answers for: back axle

Question about Patrol Police Car

1 Answer

...back axle popped out. I tried to hammer it back in but I stopped when I felt that I was applying to much force. Is there a way to remove the classic end of axle piece, insert the axle and then return ...

Ad

Question about 2004 Grand Cherokee

1 Answer

axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then

Ad

...axle. But, as long as its back in service, that's a plus. I hope that they cleaned the differential center section of all bearing and axle debris though or you will certainly have a failure in there ...

...ant replace them if anything looks like its worn, To install push the axle all the way in, and get the clip back in th egrrove, then pull axle out to seat the clip. then the large pin can go back

...back to the outer end of the axle, (where the tire goes) and push inward on the axle. It shouls move in about 1/2" or so, just enough to remove the clip. The clip should fall out easily if it is ...

Question about 2004 Grand Cherokee

1 Answer

...Press new bearings, seal and collar back onto the axle. Reassemble the rotor, caliper, etc. This can be done at home if you have access to a slide hammer and arbor press and some basic hand

...axle on passenger went back into transmission with no problem. Drivers side (new axle) will not lock into transmission.There is a ring on the end of the axle of shaft. Put both old axle and new axle ...

Question about 2003 XC70

1 Answer

...back pushing axle thru at same time,use pry bar to pop axle from ******, reversal to install, push axle into ******,pull spindal/rotor back install axle end into hole reset lower ball joint ,tie rod ...

...it then drove it and diff was loud and axle popped back out.i installed used front diff and new axles,redrove and in 4x4hi it wanders bad and L axle popped back out. don't use 4wd on hard ...

...I've removed the brake drum, the locking nuts that tighten the bolts holding the stub axle to the backing plate. The bolts that go through the stub axle mounting through the backing plate wont

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Toys Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66980 Answers

john h

Level 3 Expert

29494 Answers

Are you a Toys Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...