Questions & Answers for: adjust toilet flush pressure

Question about Toilet Onepiece Canterbury 081162047

Having trouble getting a good power flush.Would

Having trouble getting a good power flush.Would you look at the venting situation ? I adjusted the flaaper but still not the best of performance .Thanks Brian Check the flush regulator - some are ...

Question about Cimarron Comfort Height elongated 1.6 gpf toilet with Class Six tech

1 Answer

Just had new toilet put in and the flush is weak

Just had new toilet put in and the flush is weak thought it was clogged at first but is seems like a pressure problem when flusing you should be able to adjust flush from filler valve raise water ...

Question about Cimarron Comfort Height elongated 1.6 gpf toilet with Class Six tech

1 Answer

I just installed a Kohler Wellworth toilet. WhenI ...

...toilet. Then it probably has a water saver flapper that you can replace with a non water saver flapper. This will allow it to flush more. Be advised you may have to adjust the water level after the ...

Question about Cimarron Comfort Height elongated 1.6 gpf toilet with Class Six tech

1 Answer

Dear sir/madam. when flushing toilet it takes a

toilet. It should come up far enough to allow total unobstructive flow of water. If it isn't, adjust chain length until it does. Make sure there is a little slack left. If neither of these solves your

Question about 3386-6 Rialto Skylight Round Front Toilet

1 Answer

Not sure the model, but when I flush the handle

but when I flush the handle stays down? This is happening on two out opf three toilets Water pressure in the house may be to high and not allowing flappers to drop. check pressure and adjust as needed

Question about - Toilet - Two-piece - Highline - K3427-RA-G9

1 Answer

How do I adjust the

toilet You cannot adjust the pressure on the toilet. But you can adjust the stop setting screw at the top of the float arm. If the water is coming in too fast you can adjust the valve where the toilet

Question about Gerber Ultra Flush 10" White Round Front Two Piece Pressure-Assist Toilet 2

1 Answer

Toilet won't flush

...toilet, you will see a chain that will probably be laying on the bottom of the water tank. One end connects to the rubber stopper and the other end connects to the bac side of the flushing lever. ...

Question about Gerber Ultra Flush 10" White Round Front Two Piece Pressure-Assist Toilet 2

1 Answer

I have a saniflow for toilet and when flushed it makes a whirring noise and gradually goes to a loud crunching noise at this point i turn power supply off when turned back on its ok till next flush !p

...pressure regulator. it will have a bolt coming out of the top with a nut at the base of it.loosen nut. while toilet is being flushed, adjust bolt till noise stops. turn bolt clockwise to

Question about KOHLER Revival Two-Piece Elongated Toilet, White

1 Answer

TOILET DOESNT HAVE A GOOD FLUSH PRESSURE AND DOESNT FILL FAST ENOUGH

TOILET DOESNT HAVE A GOOD FLUSH PRESSURE AND DOESNT FILL FAST ENOUGH WHEN U FLUSH DOESNT GO DOWN ALL THE WAY THEN TAKES FOREVER TO FEEL BACK UP ITS THE K-4620 MODEL YR.2002 Valve needs adjustment ...

Question about American Standard 2366.100 Cadet Pressure Assisted Flush Toilet

1 Answer

Do you turn the screw to the left or right on a american standard toilet to adjust the water level in the toilet tank

toilet to adjust the water level in the toilet tank water is spilling over into the pipe and causing the toilet to flush Usually to the right will drop the float, deceasring the water level, left will