My Engineer has lost the cable wire connecting the Hard Disk and the Mother Board of Intex M52G where can I find it.?

The hard drive is not loading the operating system. If you have a floppy drive connected and there is a floppy disk in the drive, it won't boot. Remove the disk and try again. If you have no floppy drive connected, then your hard drive is no communicating with the mother board. This could be due to a disconnected power or data cable on the hard drive or the mother board end of the cable. If all the cables check out OK then your hard drive has gone bad.

Hi,
HDD not Detecting only Some region, if you HDD data cable damage, HDD power Cable damage, HDD port damage, or HDD bad sector. But normally you change HDD data or power cable or mother board port. And i suggest mother board all connection disconnect and only HDD connect and open bios and search your HDD detected.

More Technical Help TechSupportMart

Hi,Dear Customer,

1> Please check you HDD cable connector.
2> Where from connect HDD cable in mother board, this port change and be care fully connect.
3> Check HDD bad sector. If you hard disk create a bad sector then not well run any hard disk.
4> Check jumper setting, first boot & sec Boot option. you hard disk where connect first boot & sec Boot option.


I think solve you problem.

check your sata cable or IDE cable for your hard disk and double check your power supply if its connected properly

May be ur system doesnot support the harddisk. Go to BIOS settings in the Advanced option see if the hard disk is detected or not, if not then check the connections of the hard disk and then go to boot priority and change first boot device to cdrom and then try

The hard disk power cable is to be connected to the power cables that comes from the SMBS. And only the data cable is plugged on to the Mother board

dear friend
Because it must recognise the three hard disk of 250GB, and memory is not frequent to working with large amount hard disk.
It is better to work with only one hard disk of 250GB. According to mother board requirement it supports up to 500Gb Hard disk but single hard disk of 500GB.

first you connect your harddisk data cable to mother board
connect your hard disk powercode using smps
connect smps 24pine connector threw mother board
connect 12v connector threw mother board
connect cpu&external fan connections
also connect the front panel connections on mother board using mother board details

M/Boards support all makes of hard drive
Are you sure you connected it correctly
The wide ribbon cable that goes in the rear of hard drive should
1) Be connected to M/board in the No 1 connector with the stripe on cable to the No 1 pin
2) the stripe on cable should go next to the 4 pin power plug on hard drive
Also ensure your BIOS is set to Auto detect of driives

You should connect the grey wire (called IDE cable) to your hard drive and the other end of the same cable to your mother board. also find some other cables attached together (black, red, yellow and black) which have a white plastic at the end and connect that plastic to the right part on the back of your hard disk. place the hard drive in your computer and you are done.