Car Audio & Video Logo

Related Topics:

Anonymous Posted on Jun 05, 2011

2005 Mazda 6 GT V6, Bose Stereo: I'm getting an

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 1,116 Answers
  • Posted on Jun 05, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: May 14, 2011
Answers
1116
Questions
0
Helped
528087
Points
3536

The fault code refers to a CD changer error. More than likely you are looking at buying a new radio. Sorry for the bad news.

In case of a problem or clarification or my solution was insufficient, don't hesitate to post me a reply.

If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 Mazda MPV V6. I cant find the OBD2 port under the driver dash.

Question edited for a lot more clarity and toss in a LOAD of Caps
Question moved to model category.

Mazda Mpv LW5W OBD schematic from 17 pin to OBD2 16 ...

Mazda Forum https://www.mazdaforum.com > ... > Mazda MPV
Aug 7, 2015 - My Mpv has a 16 pin socket under the left side of the dash, kind of pointing down. The plug in you are looking at is for Mazda dealer ...

Diagnostic Connector Type Question - Mazda Forum
Nov 23, 2007
Where is OBD connector - '06 Mazda 6
Aug 29, 2010
OBD II Not Communicating - Mazda Forum
Dec 26, 2008
Location to perform an engine Diagnostic - Mazda Forum
Nov 20, 2007
More results from www.mazdaforum.com

SOLVED: Mazda mpv obd2 connector location

Fixya https://www.fixya.com > ... > MPV > 1998 Mazda MPV
Your ground wire connection for the OBD2 connector is located under the dash just below and to the right of the heater controls. More likely that you dont have ...
..
0helpful
2answers

I have a 1996 Nissan Maxima with a factory Bose CD player / cassette and radio and it will not turn on what's the solution

Maxima Bose Radio ' eBay

www.ebay.com/bhp/maxima-bose-radio

eBay1995 1996 1999 Nissan Maxima Pathfinder Infiniti J30 Radio BOSE CD tape Player ...Will fit and work in these with BOSE audio package only:1995 - 1999 NISSAN .... 2006Nissan Maxima OEM Bose Cassette & 6 Disc CD Player Radio CR13B ...DESCRIPTION Unit is missing some bottons, 3 of them, this item has NOT ...

Nissan Maxima Bose Stereo ' eBay

www.ebay.com/bhp/nissan-maxima-bose-stereo

eBayWill fit and work in these with BOSE audio package only:1995 - 1999 ... 1996 - 2000 NISSAN Pathfinder. 2004 2005 2006 NISSAN MAXIMA FACTORY BOSE STEREO 6 DISC ... Factory NISSAN INFINITI BOSE Radio, Tape, and CD Player. ... 6 Disc AM FM Stereo Cassette Radio Bose OEM LKQ (Fits: Nissan Maxima).

Nissan Maxima Car Stereo Removal and Repair - YouTube

? 8:52
https://www.youtube.com/watch?v=RT-SZEfeA4Q
Sep 16, 2012 - Uploaded by Factory Car Stereo Repair
Factory Car Stereo Repair .... I have nissan maximal 05..the CD part turns on but the cd won't eject...should ... I have a 2005maxima non-bose radio system. ... my speakers is super in my 05 maxima but my cd player keeps on ...

Nissan - Factory Car Stereo Repair



0helpful
1answer

MAZDA 6 Bose CD Player will not eject disc

Had this happen to my 6, they had to remove the CD player and send it away to get the disc's out and they mailed them to me, installed new bose disc changer under warrenty no problems since.
1helpful
1answer

I have bose 901 series 2 speakers, marantz 8200 and 2 marantz ma700 monoblock amps how do i hook everything up? Thankd

Do you mean SR-8200? You can't omit the details of a model number if you want a good answer.

Assuming it is...

http://www.retrevo.com/support/Marantz-SR8200-Receivers-manual/id/511ci775/t/2/

Run the 901's with the Active EQ between the receiver Front L and R Pre-Outputs and the mono block amps, one chanel to each.

Pre Out Channel X >>> Bose EQ Amplifer IN, then Bose EQ Amplier OUT >>> Monoblock IN

http://community.klipsch.com/forums/storage/74/1341919/200w%20mono%2005.jpg

I can't find a manual for the MA700. Set them up to a certain volume and then use the speaker setup routines of the SR to match everything up volume-wise. Control will be in the AVR.
0helpful
1answer

Mazda 6 V6 2005, at 58 kms/hr whole car shakes. Not from steering but feel it in my behind and it's the whole vehicle.Started when I bought the car new. Brought it back many times and trans. expert...

if the shaking is coming from the rear end, have you checked the tires to make sure you havent broken a tredd in the tire and make sure the tires are balanced correctly and one hasent lost a wheel weight and thrown it out of balance. and check the air pressure in them also. check all tires i hope this helps
0helpful
3answers

06:er07 when i run diagnostic on system. currently radio is not working even after changing bose amp

there,s a fuse in your radio if it has one ,or check the fuse if the radio is not coming on
1helpful
1answer

Can i replace my mazda 6 2.3 v4 for a 3.0 v6

Not unless you have the whole other complete car to swap parts from. starting with the wiring harness.
0helpful
1answer

06 Mazda 6, v6 won't start, jmper cables didnt wk, lights do wk

Pretty much got to be starter related. Loose connection at starter. Bad solenoid. Brushes in starter.
Rap the starter with a hammer and see if the engine will turn over after that.
If it does, you've found your problem.
1helpful
1answer

Hello, I was just wondering how to change the fuel filter on a 2005 mazda 6 v6?

Mazda Car 2005-06 Repair Guide
Fuel Filter Removal & Installation

The fuel filter on most Mazda cars can be located on a bracket in the left rear of the engine compartment, next to or beneath the brake master cylinder fluid reservoir or as part of the fuel pump assembly.

The filter on Mazda3 models is part of the fuel pump assembly.
The fuel filter is part of the pump assembly. Once the fuel pump is removed, remove the filter retainer and filter. refer to the fuel pump procedure or removal and installation.

Hope helps with this (remember rated this help) Good luck.
0helpful
1answer

Mazda 6 starting problem

You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams,
error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..
Not finding what you are looking for?

279 views

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...