Babyliss pro nano titanium flat iron - was dropped, controls will power on but will not heat

http://www.amazon.co.uk/s/?ie=UTF8&keywords=perfect+curl+babyliss+pro&tag=googhydr-21&index=aps&hvadid=24555785814&hvpos=1t1&hvexid=&hvnetw=g&hvrand=18206864247046079762&hvpone=&hvptwo=&hvqmt=b&hvdev=c&ref=pd_sl_2ky6pkn4hy_b

The Problem with BaByliss PRO Nano Titanium 1" Ultra Thin Hair Straightening/Flat Iron can be resolved if you call the company support line or web page.

There is no fuse. If you connected it to 220 which is common power in a lot of countries, then you ruined the heating element. time for a new iron.

temp sensor has gone. or the heat coil.

Does it still heat at all? There is a thermal fuse that trips if the iron gets too hot. The fuse can be purchased from DigiKey and others, but it is not easy to replace, and you need a multi-meter to check the fuse. I have repaired dozens of flat irons, not sure about that brand but they're all nearly the same.

send it back to babyliss, their customer care hotline number is 08705 133 191 & Their email address is [email protected], please rate my solution

The screw may be triangular, or Torx (star pattern), or even 'pin-in-Torx', which all require special tools. They do it to prevent people from opening them up. But you can buy the tools, and for triangular screws I ground an old screwdriver down to match the shape!

Those screws are called 'Tamper Proof' or 'Tamper Resistant'. If you google those you'll find tool sets that will open dang near anything.

Hair dryer? You tried resetting the GFCI? The clicky thing on the plug. You'd be surprised how many people don't know to do that.

Babyliss have a bad habit of the cord going bad, right at the hair dryer. I've seen a lot of them. Once you get it open and slide the rubber cord-gripper thingy back, there's a melted or burned spot in the cord. You have to cut the bad part off and wire the cord back to the dryer. Normally once that's done, you never have any more problems.