My Fisher Paykel gw612 leaking water from underneath during the spin cycle. I can't see any leaks underneath and the hoses and side of the machine stay dry. Also when it is filling it makes a slight tapping noise like the bowl is knocking something, but the machine is level????

Try running running it MT on smaller load setting a few time,s then do a smaller then you had been doing load of close. I belive yr getting or have got.water.past the.shaft seal,s. So maybe wth smaller load.inclueding.water setting you may see some change i.e. no more black speacks. Sorry.about my spelling. Am.still new

hi - I have often come across defective hoses further up along the sides of the machines - a result usually from constant rubbing onto the frame work amongst others.

The design would indicate other defects if present - if the air vaccum breather for level control or the hose defective it will have overfill amongst others - constant leak on to the floor through out the cycle - same would apply to a crack in the outer bowl - pump errors would show up if that's faulty.

Have found duct tape effective for these minor issues - the cost of replacements could be horrendous if a serviceman was to replace the harness..

Cheers

you have a leak in your outlet hose normally caused by rubbing on the drum barrel / repair with tape or replace whole hose but this brand of wASHER ITS VERY HARD TO REPLACE IF DONT KNOW HOW TO

Check the drain hose where it leaves the machine, if the square section of it is not in the plastic housing it will cut on the cabinet, if this has happened replace the hose they are difficult to repair, Other possibilities, pump is leaking, and check that the inlet hoses are not leaking and have washers in every connection.

is the machine level

sometimes too much detergent, or extra cleaners like oxy clean) will cause lots of foam which will cause the water level sensor to misread, or foam over the top of the drum. if this is not the problem, you will have to tilt the machine on its side and look for loose or damaged hoses. the play in the tub will not cause leaking

possible its form the pmp assy underneath, youll need to tip unit back( the bottoms open, look for leaks, should be quite noticable

hi there,

the leak underneath could be from the pump or the drain hose. some washers have a tub to pump boot that sometimes springs a leak.

for a 4-month-old washer, i would certainly hope you pay nothing. F&P appliances come with at least a 2 year warranty. check your user & care guide for warranty information.

check out the DRAIN MOTOR PUMP , its a small motor with 2 hoses connected to it , it could be clogged , need to remove it , inspect inside the impellers for any debri , clean it , re install and try again , hope this helpful AJ

diverter valve is not switching to pump the water out. instead it is resurculating back into the tub.