My display is crazy, i can´t se at anything, what´s the problem? I have tryed to change display with no luck! Greetigs

Have you tried adjusting the bobbin tension? There's a small screw on the bobbin case so the bobbin can be adjusted. only turn the screw a little at a time. Also be sure your top tension isok. However if you still need help these days you can buy a new bobbin case and a new top tension, both will be adjusted already to use from the factory. don't let it drive you crazy they sell the preadjusted parts for us few that just want to sew not be a tech to just sew a blouse etc. I hope this helps. good luck
Lynn

< - Let ME know your full model number from the tag and I can give you complete detailed instructions on how you or a friend can fix it.

"SE" means you have a shorting membrane keypad.

If and when an oven is coming on or doing anything by itself, this is very dangerous and can result in a fire.

So until it is repaired, please leave it unplugged or leave the door open when it's not in use, and of course one should never leave a microwave unattended while cooking.

That code (5E, not SE) means the drainage is clogged. The code appears after 15 minutes of trying to drain the tube (not sure that´s the word, may be turbine, barrel...). check the lateral filter (a big plastic twist-off cap) for any solid that may be clogging the drainage

check your interne tis ti hathway or others dosent matters mater is se rvice so you call the engineer

the startalk takes does not store the time, it takes the time and date from the phone system. to change the time on the phone system try feature **TIME (8463) password CONFIG (266344) from a phone with the 3 soft buttons under the display it does depend on the model and software level as to whether this will work and also presuming nobody has changed the default password

Start the "Windows Compatibility Wizard".
Select that you want to install a "Windows XP Application".
Point to the CD-ROM containing the software.
Install it by selecting the 'setup.exe' file.

it is chain, there is no need to change.

Your rpm signal shares the same connection with the primary coil terminals. Take off the contact connections, and clean metal parts with small grid sand paper. Put them back and tighten securely. It should be OK. If it is not, then there is a problem with the display. Good luck.