Kay i have a evader ext and everything works fine except when i go to give it throttle it just like jerks forward a bit and *** oon as i lift up the back it works fine so when i put it on the ground and go to drive i gotta ease on the throttle really slow in order for me to be able to move i dont know if it is the controler or the car its self ? can someone please help me im getting so confused

Hi Kay, I'm glad to help! Kay, if you turn the key on and nothing happens at all. In other words: You do not here the engine turning over and sometimes the dash lights and guages do not work. Here's your most likely problem. Your vehicle has what they call a WIN Module which is the same thing as an old style Ignition Switch. When the WIN goes bad it's shuts everything down and nothing happens when you turn the ket to the start position. This WIN will need to be replace at the dealership because they will need to program the WIN and then program the KEYs to the new WIN. NOTE: DO NOT be alarmed if the tell you that you need new keys because they want program to the new WIN, sometimes this happens in fact so often that the manufacture started sending NEW KEYS with the WIN, But, only on some year models. Hope this helps and have an awesome day Kay.

Hi,
The belt is slipping a bit... try tightening the belt a bit and you will be fine...

heatman101

There are usually 3 motors for power seats, 1 to tilt the seat, 1 to raise and lower the seat, and 1 to move the seat back and forth. I would think that motor is bad. Check for any obstuctions to the seat track.

I suggest reprogramming the esc

Sounds like it could be your EGR valve.... have the engine light scanned and that will narrow down the cause

You have bad motor or transmission mounts check it with someone stepping on the gas and the brake and have them put it in forward then reverse watch how much engine play there is or how far it travels back and forth if it's more than a half inch that’s your problem, if not post here and will give you the next procedure to check.

Find the cruise control fuse and pull it out,if that doesn`t stop it,replace fuse back in.Then replace the throttle position switch.

I have found that 99 percent of the time when this happens it is carb related. It is very possible that you picked a a small piece of grit or trash in the high speed jet of one, or both, of your carbs. I would be willing to bet that pulling the carbs and cleaning them will resolve your problem. I am almost positive that will fix your problem, mainly because it sounds like you've already tried everything else. I had this same problem last season, and what had happened was I left the vent open on my fuel tank, we got a shower, and I pulled just a small bit of water into the carb and that was it, she would not do anything over idle until I pulled the carbs and cleaned them. i even put the water muffs on it and let it run in the yard for about an hour thinking that it would burn the water out, but i was wrong. Anyway, clean the carbs and i think you'll be in good shape, Good Luck.

Try to program the speed controller, or re-program. Make sure your wire into the receiver is facing the correct direction, and make sure you have a charged battery.

Check the servo reversing switch on your transmitter,or swap your motor wires. Hope this helps